Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 700

Thrust bearing

JAG-061

Removal

1. Remove the front subframe

For additional information, refer to:

Front Subframe - 2.0L Duratorq-

TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma

(502-00 Uni-Body,

Subframe and Mounting System, Removal and Installation).

2. NOTE: Note the orientation of the bushing before removal.

Using the special tools, remove the front subframe mounting bushing.

Installation

1. Fit the bushing to the special tool.

2.

CAUTION: Make sure excessive pressure is not used when

installing the bushing. Failure to follow these instructions may result in
damage to the subframe.

• NOTE: Apply a suitable amount of Shell gravex oil 973 to the bushing
before installing.

• NOTE: Make sure the bushing is correctly orientated.

Using the special tools, partially install the bushing.

3. Remove the special tools.

4. Using the special tools, fully seat the bushing.

5. Install the front subframe

For additional information, refer to:

Front Subframe - 2.0L Duratorq-

TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma

(502-00 Uni-Body,

Subframe and Mounting System, Removal and Installation).

Published: 11-May-2011

Uni-Body, Subframe and Mounting System - Rear Axle Crossmember Bushing

Removal and Installation

Special Tool(s)

Forcing nut

204-274

Forcing screw

204-275

Support cup

204-299

Bush remover

204-271

Bush installer

204-245

Removal

1. Remove the drive differential. For additional information, refer to

Section

205-02 Rear Drive Axle/Differential

.

2. Detach the damper.

Left-hand side shown, right-hand side similar.

3. Detach the wheel knuckle mounting bracket.

4. Loosen the rear subframe mounting retaining bolts.

Left-hand side shown, right-hand side similar.

5. Using the special tools, remove the rear axle crossmember bush.

Installation

1. Using the special tools, install the rear axle crossmember bush.

2. NOTE: The final tightening of the suspension components must be
carried out with the vehicle on its wheels.

Tighten to 126 Nm.