Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 630
Published: 11-May-2011
Glass, Frames and Mechanisms - Door Window Motor Initialization
General Procedures
1. NOTE: After the battery has been disconnected it is necessary to
initialize each door window motor separately to operate the "one-touch"
up function.
Operate the window control switch until the door window glass is in the
fully closed position, continue to operate the window control switch for a
further two seconds.
2. Release the window control switch.
3. Operate the window control switch in the closed position and continue
to operate the window control switch for a further two seconds.
4. Operate the window control switch until the door window glass is in the
fully open position ("one-touch" down).
5. NOTE: If the door window motor initialization has been completed
correctly, when the window control switch is operated, the door window
glass should move to the fully closed position ("one-touch" up)
automatically.
• NOTE: If the door window glass does not fully close automatically ("one-
touch" up), repeat the complete procedure.
Operate the window control switch once to the close position.
6. Repeat the door window motor initialization for each door window
motor.
Published: 11-May-2011
Glass, Frames and Mechanisms - Liftgate Window Glass Adjustment
General Procedures
1. Make sure the rear wiper mounting arm is in the parked position.
2. Open the liftgate window glass.
3. Open the liftgate.
4. Remove the liftgate trim panel.
For additional information, refer to:
Liftgate Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).
5. Loosen the rear wiper motor retaining nuts.
6. Close the liftgate.
7. NOTE: The aid of an assistant in the loadspace will be required to align
the rear wiper motor to the liftgate window glass.
Make sure the liftgate glass latch and rear wiper mounting arm locate
correctly into the liftgate latch actuator and rear wiper motor.
8. Close the liftgate glass.
9. CAUTIONS:
With the aid of an assistant in the loadspace, fully tighten the rear
wiper motor retaining nuts. Failure to follow this instruction may result in
damage to the vehicle.
Make sure the rear wiper motor does not move whilst tightening the
retaining nuts. Failure to follow this instruction may result in damage to
the vehicle.
Tighten the rear wiper retaining bolts in the order shown.
1. Tighten to 8 Nm.
10. Visually check the liftgate window glass for correct alignment.
11. Install the liftgate trim panel.
For additional information, refer to:
Liftgate Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).
Published: 11-May-2011
Glass, Frames and Mechanisms - Front Door Window Glass
Removal and Installation
Removal
1. Lower the front door window glass approximately 290 mm (11.41 in).
2. Remove the front door trim panel.
For additional information, refer to:
Front Door Trim Panel
(501-05
Interior Trim and Ornamentation, Removal and Installation).
3.
CAUTION: Do not touch the adhesive surface as rebonding will be
impaired.
Detach the front door weathershield.
4. Remove the front door window glass.
Loosen the retaining bolts.
Installation
1. Install the front door window glass, but do not tighten the retaining
bolts.
2. Connect the window control switch electrical connector.
3. Power the front door window glass to the fully closed position.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст