Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 368

45. Remove the transaxle retaining bolts.

46. Align the powertrain assembly jack to the transaxle.

Secure the transaxle to the powertrain assembly jack.

47. Remove the transaxle retaining bolt.

48. NOTE: Carry this step if an early condition transaxle is being removed.

• NOTE: Vehicles with 2.5L and 3.0L engines shown, vehicles with 2.0L
engine similar.

Remove the transaxle retaining bolt

Remove the transaxle dust cover.

49. NOTE: Carry this step if a later condition transaxle is being removed.

• NOTE: Vehicles with 2.5L and 3.0L engines shown, vehicles with 2.0L
engine similar.

Remove the transaxle dust cover.

50. NOTE: Carry this step if a later condition transaxle is being removed.

• NOTE: Vehicles with 2.5L and 3.0L engines shown, vehicles with 2.0L
engine similar.

Remove the transaxle retaining bolt.

51.

W ARNING: Do not let the torque converter drop out of the

transaxle. Failure to follow this instruction may result in personal injury.

Remove the transaxle.

Detach the transaxle from the drive plate.

Lower the powertrain assembly jack and transaxle assembly.

Published: 11-May-2011

Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Input Shaft Seal

Disassembly and Assembly of Subassemblies

Special Tool(s)

Link shaft oil seal installer

205-115

1. Remove the transmission assembly. For additional information, refer to

Transmission

.

2.

CAUTION: Do not let the torque converter drop out of the

transmission. Failure to follow this instruction may result in personal
injury.

Remove the torque converter.

Drain any remaining fluid into a suitable container.

3. NOTE: Make sure the transmission housing seal face is not damaged
when removing the torque converter seal.

Using a suitable tool, remove the torque converter seal.

4. NOTE: Using a suitable Metal surface cleaner W SE-M5B392-A or
equivalent meeting Jaguar specification. clean the seal face on the
housing before fitting the new seal.

Clean and inspect the transmission housing seal face.

5. Using the special tool, install a new torque converter seal.

6.

CAUTION: Do not let the torque converter drop out of the

transmission. Failure to follow this instruction may result in personal
injury.

• NOTE: The torque converter hub must engage fully in the oil pump drive
gear.

Install the torque converter.

7. Install the transmission assembly. For additional information, refer to

Transmission

.