Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 578

Published: 11-May-2011

Navigation System - Navigation System

Diagnosis and Testing

Principle of Operation

For a detailed description of the navigation system, refer to the relevant Description and Operation sections in the workshop manual. REFER
to:

Navigation System

(419-07 Navigation System, Description and Operation).

Inspection and Verification

1. Verify the customer concern.

1.

2. Visually inspect for obvious signs of mechanical or electrical damage.

2.

Visual Inspection Chart

Mechanical

Electrical

Navigation system DVD player Mechanism

Navigation system display
Navigation system module
GPS antenna
W iring harness for damage and corrosion
Electrical connector(s)
ABS Module
Audio unit

3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next

step.

3.

4. If the cause is not visually evident, check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index.

4.

DTC Index

CAUTION: W hen probing connectors to take measurements in the course of pin point tests, use the adapter kit, part number

3548-1358-00

• NOTE: If the control module/component is suspect and the vehicle remains under manufacturer warranty, refer to the warranty policy and
procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new component.

• NOTE: When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places and with a
current calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.

• NOTE: Check and rectify basic faults before beginning diagnostic routines that involve pinpoint tests.

• NOTE: Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.

• NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause.
Always check for loose connections and corroded terminals.

DTC

Description

Possible Cause

Action

B1342 ECU is defective

Satellite navigation system module -
internal ECU failure

Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. check navigation
system module for internal failure. Install a new module as
required, refer to the new module installation not at the top of
the DTC index.

B2197 TV module error

Satellite navigation system display -
module or switch fault

Carry out any pinpoint tests associated with this DTC using the
manufacturers approved diagnostic equipment. Check the
satellite navigation system module for failure. Install a new
module as required, refer to the new module installation note
at the top of the DTC index.

B2198 Traffic Master module

error

Satellite navigation system module -
traffic master module fault

Refer to electrical circuit diagrams, notes and check navigation
system module communication circuit to traffic master module
for failure. install a new module as required, refer to the new
module installation note at the top of the DTC index.

B2199 VICS Module Error

Satellite navigation system module -
VICS (vehicle information control
system) module fault

Refer to electrical circuit diagrams, notes and check navigation
system module communication circuit to vehicle information
control system module for faults. install a new module as
required, refer to the new module installation note at the top
of the DTC index.

B2201 No communication

with traffic master
module

Satellite navigation system module -
traffic master communication fault. This
DTC is logged if the module is not
fitted. It must be masked out by the
tester when the module is not fitted to
a particular vehicle

Refer to electrical circuit diagrams, notes and check navigation
system module communication circuit to traffic master module
for a fault. Install a new module as required, refer to the new
module installation note at the top of the DTC index.

B2202 No communication to

VICS module

Satellite navigation system module to
vehicle information control module -
communication fault. This DTC is logged
if the module is not fitted. It must be
masked out when it is not fitted to a
particular vehicle.

Refer to electrical diagrams, nots and check navigation system
module communications circuit to vehicle information control
module for faults.

B2204 GPS Antenna

connection open or
short

Satellite navigation module (GPS)
Antenna - open circuit or short circuit

Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. refer to electrical
circuit diagrams, notes and check navigation system module
(GPS) antenna for open or short circuit.

DTC

Description

Possible Cause

Action

B2205 GPS receiver fault

Satellite navigation system module -
global positioning satellite receiver fault

Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to the
electrical circuit diagrams, notes and check navigation system
module global positioning satellite (GPS) antenna circuit.
Check the antenna is not obstructed (vehicle must be outside
when being tested). Replace module is fault persists.

B2206 Gyroscope fault

Satellite navigation system module -
gyroscope fault

Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to electrical
circuit diagrams, nots and check navigation system module for
faults. Install a new module as required, refer to the new
module/component installation note at the top of the DTC
index.

B2207 Internal ECU ROM

checksum fault

Satellite navigation system - module
internal failure

Refer to electrical circuit diagrams, notes and check the
navigation system module for faults. Install a new module as
required, refer to the new module/component installation note
at them top of the DTC index.

B2208 Navigation module to

display and switch
module
communication error

Satellite navigation system module -
communication to display and switch
module fault.

Refer to electrical circuit diagrams, notes and check navigation
system display and switch module communication circuit for
fault

B2646 Antenna circuit open

circuit #1

Satellite navigation system module
navigation system antenna - open
circuit

refer to electrical diagrams, notes and check navigation
systems antenna circuit for open circuit. To restore power the
fault must be removed and the user must key off and on.

B2647 Antenna circuit open

circuit #2

Satellite navigation system module
navigation system antenna - open
circuit

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for open circuit. To restore power the
fault must be removed and the user must key off and on.

B2648 Antenna circuit open

circuit #3

Satellite navigation system module
navigation system antenna - open
circuit

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for open circuit. To restore power the
fault must be removed and the user must key off and on.

B2649 Antenna circuit open

circuit #4

Satellite navigation system module
navigation system antenna - open
circuit

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for open circuit. To restore power the
fault must be removed and the user must key off and on.

B2650 Antenna circuit short

circuit #1

Satellite navigation system module
navigation system antenna - short to
power or ground

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for short to power or ground. To
restore power the fault must be removed and the user must
key off and on.

B2651 Antenna circuit short

circuit #2

Satellite navigation system module
navigation system antenna - short to
power or ground

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for short to power or ground. To
restore power the fault must be removed and the user must
key off and on.

B2652 Antenna circuit short

circuit #3

Satellite navigation system module
navigation system antenna - short to
power or ground

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for short to power or ground. To
restore power the fault must be removed and the user must
key off and on.

B2653 Antenna circuit short

circuit #4

Satellite navigation system module
navigation system antenna - short to
power or ground

Refer to electrical diagrams, notes and check navigation
systems antenna circuit for short to power or ground. To
restore power the fault must be removed and the user must
key off and on.

B2655 Switch and display

module is defective

Satellite navigation system module -
display faulty

Refer to electrical circuit diagrams, notes and check navigation
system display and switch module for failure. Install a new
display module as required. Refer to the new
module/component installation note at the top of the DTC
index

B2656 DVD (Digital Versatile

Disk) error

Satellite navigation system module
-DVD error (DVD is integral to the
navigation system module ECU)

Refer to electrical circuit diagrams, notes and check navigation
system module for faults. Install a new module as required.
Refer to the new module/component installation note at the
top of the DTC index

Published: 11-May-2011

Navigation System - Navigation System Antenna4-Door, VIN Range: E96603->J39905

Removal and Installation

Removal

1. Detach the rear door opening weather-strips.

Left-hand shown, right-hand similar.

2. Remove the rear seat side bolsters. For additional information, refer to

Section

501-10 Seating

.

3. Remove the C-pillar trim panels. For additional information, refer to

Section

501-05 Interior Trim and Ornamentation

.

4. Detach the seat belt reel trim panels.

Left-hand shown, right-hand similar.

5. Remove the rear seat backrest latch covers.

Left-hand shown, right-hand similar.

6. Detach the parcel shelf trim panel.

7. Remove the GPS antenna.

1. Disconnect the GPS antenna electrical connector.

2. Remove the GPS antenna.

1. Remove the pop rivet.

Installation

1. To install, reverse the removal procedure.