Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 249
Published: 11-May-2011
Engine Cooling - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Cooling
Module
Removal and Installation
Removal
All Vehicles
1. Remove the air cleaner.
For additional information, refer to:
Air Cleaner
(303-12A Intake Air
Distribution and Filtering - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA
V6 - AJ27, Removal and Installation).
2. Remove the air cleaner intake duct.
3.
CAUTION: Make sure that the air conditioning (A/C) condenser is
not damaged when installing the retaining straps. Failure to follow this
instruction may result in damage to the vehicle.
• NOTE: To allow the cooling module to be partially lowered and supported
when the radiator support beam is removed, suitable retaining straps must
be installed to the A/C condenser.
Loosely attach suitable retaining straps to the A/C condenser.
4. Drain the cooling system.
For additional information, refer to:
Cooling System Draining, Filling and
Bleeding
(303-03A Engine Cooling - 2.0L NA V6 - AJV6/2.5L NA V6 -
AJV6/3.0L NA V6 - AJ27, General Procedures).
5. Detach the lower coolant hose from the radiator and position to one
side.
6. Reposition the coolant hose from the engine oil cooler to the
thermostat housing and secure it to the front cross member using a
suitable retaining strap.
7. Lower the vehicle.
Vehicles built up to VIN:E71956
8. Detach the radiator vent hose from the radiator.
9. Detach the upper coolant hose from the radiator.
10. Disconnect the cooling fan motor control module electrical connectors.
Vehicles built from VIN:E71957
11. Detach the radiator vent hose from the radiator.
12. Detach the upper coolant hose from the radiator.
13. Disconnect the cooling fan motor control module electrical connector.
All vehicles
14. Raise the vehicle.
15. Remove the air splitter grille.
16. Remove the front towing eye trims.
Vehicles With Automatic Transmission
17. NOTE: Left-hand side shown, right-hand side similar.
Detach the power assisted steering oil cooler inlet and return pipes.
Allow the power assisted steering fluid to drain into a suitable
container.
Using suitable blanking plugs, blank the exposed ports.
Vehicles With Manual Transmission
18. Detach the power assisted steering oil cooler inlet pipe.
Allow the power assisted steering fluid to drain into a suitable
container.
Using suitable blanking plugs, blank the exposed ports.
All Vehicles
19. Remove the radiator support beam.
20.
CAUTION: Apply suitable tape to the right-hand side lower
section of the front bumper to prevent damage to the paintwork from the
A/C pipe when the cooling module is lowered. Failure to follow this
procedure may cause damage to the vehicle.
Remove the right-hand side A/C condenser retaining bolt from the
radiator.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст