Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 428

8. Using the engine support bracket raise the powertrain assembly.

Adjust the engine support bracket to align the transaxle to the
transaxle mount bracket.

9. Install the transaxle mount bracket securing studs.

Tighten to 80 Nm.

10. Install the clutch master cylinder to clutch slave cylinder high pressure

pipe support bracket.

11.

CAUTION: If brake fluid is split on the paintwork, the affected

area must be washed down immediately with cold water. Failure to follow
this instruction may result in damage to the vehicle.

Attach the clutch master cylinder to clutch slave cylinder high pressure
pipe to the clutch slave cylinder.

Install the clutch master cylinder to clutch slave cylinder high
pressure pipe retaining clip.

12. Attach the clutch master cylinder to clutch slave cylinder high pressure

pipe to the support bracket.

Remove the pipe clamp from the clutch master cylinder to clutch
slave cylinder high pressure pipe.

13. Connect the reverse lamp switch electrical connector.

14. Install the transaxle retaining bolts.

Tighten to 48 Nm.

15. Install the transaxle retaining bolt.

Tighten to 48 Nm.

16. Install the starter motor.

Tighten to 35 Nm.

17. Attach the starter motor solenoid electrical connector.

Tighten to 6 Nm.

18. Attach the starter motor electrical connector.

Tighten to 12 Nm.

19. Attach the starter motor solenoid cover.

20. Remove the engine support bracket.

21. Remove the engine support bracket.

22. Attach the wiring harness to the camshaft cover retaining stud.

Tighten to 6 Nm.

23. Install the intake manifold support bracket.

Tighten to 10 Nm.

24. Attach the electrical connector to the intake manifold support bracket.

25. Attach the positive crankcase ventilation (PCV) hose to the intake

manifold.

26. Remove the engine support bracket.

27. Install the air cleaner mount bracket.

Tighten to 6 Nm.