Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 290
Installation
1. Install the accessory drive belt.
2. Attach the accessory drive belt tensioner assembly.
Tighten to 47 Nm.
3. NOTE: Loosely install the generator retaining nuts.
Attach the generator.
4. Install the generator retaining bolt.
Tighten to 47 Nm.
5. Tighten to 47 Nm.
6. Connect the generator electrical connector.
7. Attach the generator positive cable.
Tighten to 8 Nm.
8. Using the special tool, install the accessory drive belt.
9. Install the right-hand wheel arch liner access panel.
10. Install the right-hand road wheel.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
11. Install the air deflector.
For additional information, refer to:
Air Deflector - 2.0L Duratorq-
TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma
(501-02 Front End Body
Panels, Removal and Installation).
12. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01 Battery,
Mounting and Cables, General Procedures).
Published: 11-May-2011
Accessory Drive - Accessory Drive Belt2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA
V6 - AJ27
Removal and Installation
Special Tool(s)
Accessory Belt De-tensioner
303-703
Removal
1. Disconnect the battery ground cable. For additional information, refer to
Section
414-01 Battery, Mounting and Cables
.
2. Remove the splash shield.
3. Remove the wheel and tire assembly. For additional information, refer
to Section
204-04 Wheels and Tires
.
4. Detach the accessory drive belt.
1. Using the special tool, de-tension the accessory drive belt.
2. Detach the accessory drive belt.
5. Remove the accessory drive belt.
1. Slacken the tensioner.
2. Remove the accessory drive belt.
Installation
1. To install, reverse the removal procedure.
Tighten to 47 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст