Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 654
14. CAUTIONS:
With the aid of an assistant in the loadspace, fully tighten the rear
wiper motor retaining nuts. Failure to follow this instruction may result in
damage to the vehicle.
Make sure the rear wiper motor does not move whilst tightening the
retaining nuts. Failure to follow this instruction may result in damage to
the vehicle.
Tighten the rear wiper motor retaining nuts in the sequence shown.
Tighten to 8 Nm.
15. Visually check the liftgate window glass for correct alignment.
16. Install the liftgate trim panel.
For additional information, refer to:
Liftgate Trim Panel
(501-05 Interior
Trim and Ornamentation, Removal and Installation).
Published: 11-May-2011
Handles, Locks, Latches and Entry Systems - Luggage Compartment Lid Latch Actuator
Removal and Installation
Removal
1. Remove the luggage compartment lid latch actuator trim panel.
2. Disconnect the luggage compartment lid latch actuator electrical
connector.
3. Remove the luggage compartment lid latch actuator.
Installation
1. To install, reverse the removal procedure.
Tighten to 10 Nm.
Published: 11-May-2011
Handles, Locks, Latches and Entry Systems - Rear Door Lock Actuator
Removal and Installation
Removal
1. Remove the rear door trim panel. For additional information, refer
toSection
501-05 Interior Trim and Ornamentation
.
2.
CAUTION: Do not touch the adhesive surface as re-bonding will be
impaired.
Peel back the weathershield.
3. Remove the rear door window glass run retaining bracket.
4. Disconnect the rear door latch exterior handle connecting rod.
5. Detach the rear door latch.
6. Disconnect the electrical connectors.
7. Remove the rear door latch actuator.
1. Detach the rear door latch actuator release cable.
2. Disconnect the rear door latch actuator release cable.
3. Remove the rear door latch actuator.
Installation
1. To install, reverse the removal procedure.
Tighten to 7 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст