Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 480
Published: 11-May-2011
Acceleration Control - Accelerator Cable2.0L NA V6 - AJV6
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to Section
414-01 Battery, Mounting
and Cables
.
2. Detach the accelerator cable.
1. Position the accelerator actuator to the fully open position.
2. Detach the accelerator cable.
3. Detach the outer accelerator cable.
4. Detach the accelerator cable from the accelerator pedal.
5. Disconnect the engine control module (ECM) electrical connector.
6. Remove the accelerator cable.
Detach the accelerator cable grommet.
Installation
1. To install, reverse the removal procedure.
2. Tighten to 5 Nm.
3. Adjust the accelerator cable.
For additional information, refer to
Accelerator Cable Adjustment-2.0L
in
this section.
Published: 11-May-2011
Acceleration Control - Accelerator Pedal
Removal and Installation
Removal
Vehicles with 2.0L engine
1. Detach the accelerator cable.
1. Position the accelerator actuator to the fully open position.
2. Detach the accelerator cable.
2. Detach the accelerator cable.
Vehicles with 2.5L, 3.0L or diesel engine
3. Disconnect the accelerator pedal electrical connector.
All vehicles
4. NOTE: Vehicles with 2.5L, 3.0L or diesel engine shown, 2.0L similar.
Remove the accelerator pedal retaining nuts.
5. Remove the accelerator pedal.
Installation
1. NOTE: Vehicles with 2.5L, 3.0L or diesel engine shown, 2.0L similar.
To install, reverse the removal procedure.
Tighten to 9 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст