Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 109
Published: 11-May-2011
Power Steering - Power Steering Fluid Cooler2.0L Duratorq-TDCi
Removal and Installation
Removal
1. Remove the radiator splash shield. For additional information, refer to
For additional information, refer to:
Radiator Splash Shield
(501-02 Front
End Body Panels, Removal and Installation).
.
2. Disconnect the power assisted steering oil cooler inlet and outlet hoses.
Left-hand side shown, right-hand side similar.
Drain the fluid into a suitable container.
3. Remove the power assisted steering oil cooler.
1. Remove the mounting bolts.
2. Remove the power assisted steering oil cooler.
Installation
1. To install, reverse the removal procedure.
Tighten to 7 Nm.
2. NOTE: If the cooler is being replaced for leakage or noise related issues
and there is no evidence of fluid contamination, there is no need to
replace the reservoir.
In some cases where the fluid clearly contains particulate matter, and
the system continues to function, flush the system with fresh fluid and
replace the reservoir, as there is the possibility that the reservoir
internal filter may be damaged or faulty.
Published: 11-May-2011
Power Steering - Power Steering Fluid Cooler2.2L Duratorq-TDCi (110kW/150PS) -
Puma
Removal and Installation
Removal
1. Remove the radiator splash shield.
For additional information, refer to:
Radiator Splash Shield
(501-02 Front
End Body Panels, Removal and Installation).
2. Disconnect the power steering fluid cooler hoses.
Drain the fluid into a suitable container.
3. Remove the power steering fluid cooler retaining bolt.
4. Remove the power steering fluid cooler.
Detach the power steering fluid cooler from the retaining clip.
Installation
1. To install, reverse the removal procedure.
Tighten to 7 Nm.
2. NOTE: If the cooler is being replaced for leakage or noise related issues
and there is no evidence of fluid contamination, there is no need to
replace the reservoir.
In some cases where the fluid clearly contains particulate matter, and
the system continues to function, flush the system with fresh fluid and
replace the reservoir, as there is the possibility that the reservoir
internal filter may be damaged or faulty.
Published: 11-May-2011
Power Steering - Power Steering Fluid Reservoir
Removal and Installation
Removal
1.
CAUTION: If power steering fluid is spilt on the paintwork, the
effected area must be immediately washed down with cold water.
Remove the power steering fluid reservoir.
1. Disconnect the power steering supply and return hoses.
1. Drain the fluid into a suitable container.
2. Remove the power steering reservoir bolts.
3. Remove the power steering reservoir.
Installation
1.
CAUTION: Use only Jaguar specification Dexron 2E power assisted
steering oil.
To install, reverse the removal procedure.
2. Bleed the power steering system. For additional information, refer to
Section
211-00 Steering System - General Information
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст