Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 664
Published: 11-May-2011
Roof Opening Panel - Roof Opening Panel Glass
Removal and Installation
Removal
• NOTE: Make sure the roof opening panel glass is in the closed position.
1. Remove the roof opening panel glass screws.
2. Remove the roof opening panel glass.
Installation
1. To install, reverse the removal procedure.
Tighten to 3 Nm.
2. Check, and if necessary, adjust the roof opening panel alignment. For
additional information, refer to
Roof Opening Panel Alignment
.
Published: 11-May-2011
Roof Opening Panel - Roof Opening Panel Motor
Removal and Installation
Removal
1. Remove the overhead console. For additional information, refer to
Section
501-12 Instrument Panel and Console
.
2. Detach the roof opening panel motor.
3. Remove the roof opening panel motor.
Disconnect the electrical connector.
Installation
1.
CAUTION: If motor oscillation is detected, loosen the motor
screws, operate the roof opening panel, then retighten the motor screws.
If necessary repeat this procedure.
Syncronize the roof opening panel motor. Refer to
Motor Synchronization
—Calibration
.
2. To install, reverse the removal procedure.
Tighten to 3 Nm.
Published: 11-May-2011
Roof Opening Panel - Roof Opening Panel Shield
Removal and Installation
Removal
1. Partially open the roof opening panel.
2. Detach the front of the roof opening panel shield.
1. Position the center of the roof opening panel shield
downwards.
2. Position the roof opening panel shield forwards.
3. Fully open the roof opening panel.
4. Detach the roof opening panel shield.
1. Position the center of the roof opening panel shield upwards.
2. Detach the roof opening panel shield guide pads.
5. Remove the roof opening panel shield.
Rotate the roof opening panel shield.
Installation
1.
CAUTION: To prevent damage to the roof opening panel shield use
a steel rule to compress the guide pads.
To install reverse the removal procedure.
Published: 11-May-2011
Roof Opening Panel - Roof Opening Panel Weatherstrip
Removal and Installation
Removal
1. Remove the roof opening panel glass. For additional information, refer
to
Roof Opening Panel Glass
.
2. Remove the roof opening panel glass seal.
Installation
1.
CAUTION: Make sure the roof opening panel glass seal is fully
seated in the glass channel.
To install, reverse the removal procedure.
Position the roof opening panel seal seam in the center of the rear
facing side of the roof opening glass.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст