Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 235

42. Attach the engine wiring harness retaining clip.

43.

CAUTION: Make sure that the electrical connector locates

correctly in the ECM. Do not force or overtighten the electrical connector.
Failure to follow this instruction may result in damage to the components.

• NOTE: Bolt remains captive in the ECM electrical connector.

Using the special tool, connect the ECM harness electrical connector.

Tighten to 10 Nm.

44. Attach the engine wiring harness electrical connector.

45. Attach the engine wiring harness retaining clip.

46. Connect the engine wiring harness electrical connector.

Tighten to 10 Nm.

47. Connect the fuel lines.

For additional information, refer to:

Quick Release Coupling - Push

Connect

(310-00 Fuel System - General Information, General

Procedures).

Remove the blanking plugs.

48. NOTE: Install new O-ring seals.

• NOTE: Un-cap the exposed ports.

Connect the air conditioning compressor lines.

49. Fully tighten the air conditioning compressor line retaining bolt.

Tighten to 20 Nm.

50. NOTE: Un-cap the exposed ports.

Connect the exhaust gas recirculation (EGR) valve vacuum pipe.

51. NOTE: Un-cap the exposed ports.

Install the power assisted steering hose.

52. Attach the power assisted steering hose.

53. Connect the power assisted steering hose.

54. Install the exhaust manifold to EGR valve tube.

For additional information, refer to:

Exhaust Gas Recirculation (EGR)

Cooler to EGR Valve Tube

(303-08 Engine Emission Control - 2.0L

Duratorq-TDCi/2.2L Duratorq-TDCi (110kW/150PS) - Puma, Removal and
Installation).

55. Connect the charge air cooler hose.

Tighten to 4 Nm.

56. Connect the radiator upper coolant hose.

57.

CAUTION: If brake fluid is spilt on the paintwork, the affected

area must be immediately washed down with cold water.

• NOTE: Un-cap the exposed ports.

• NOTE: Remove the tie strap.

Attach the clutch slave cylinder pipe.

1. Connect and fully seat the clutch slave cylinder pipe and

retaining clip.

2. Attach the clutch slave cylinder pipe.

58. Connect the charge air cooler hose.

Tighten to 4 Nm.

59. Attach the wiring harness to the battery tray mount.

60. Connect the battery cables.