Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 695
17. Attach the selector cable.
18. Connect the selector cable.
Tighten to 10 Nm.
19. Attach the selector cable.
20. Install the selector cable shield.
Tighten to 10 Nm.
All vehicles
21. Attach the rear of the steering gear cooling pipe.
Tighten to 7 Nm.
22. Attach the front of the steering gear cooling pipe.
Tighten to 7 Nm.
Vehicles with high intensity discharge headlamps
23. Connect the high intensity discharge (H.I.D) sensor drop arm.
All vehicles
24. NOTE: Left-hand shown, right-hand similar.
Attach the stabilizer bar link arms.
Tighten to 48 Nm.
25. NOTE: Right-hand shown, left-hand similar.
Install the lower arm ball joint retaining nut and bolt.
Tighten to 83 Nm.
26. Install the muffler inlet pipe.
For additional information, refer to:
Muffler Inlet Pipe - 2.0L NA V6 -
AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
(309-00 Exhaust System,
Removal and Installation).
27. Cut and remove the tie straps securing the outer casing of the
driveshaft universal joint.
Cut and remove the tie straps securing the driveshaft to the front
exhaust hanger.
28. Connect the driveshaft to the transfer case.
29. CAUTIONS:
INSTALLING A NEW DRIVESHAFT. If a new driveshaft is to be
installed, no gasket is required between the driveshaft and the drive
pinion flange. Failure to follow this instruction may result in damage to
the vehicle.
INSTALLING THE ORIGINAL DRIVESHAFT. If a gasket was removed
from between the driveshaft and the drive pinion flange on the driveshaft
removal procedure, make sure to install a new gasket. If no gasket was
removed from between the driveshaft and the drive pinion flange on the
driveshaft removal procedure, a new gasket is not required. Failure to
follow this instruction may result in damage to the vehicle.
Attach the driveshaft universal joint.
1. Attach the driveshaft universal joint.
2. Install new driveshaft retaining bolt link washers.
3. Install new driveshaft retaining bolts
Tighten to 44 Nm.
30. Install the engine roll restrictor.
Install the engine roll restrictor retaining bolt.
31. Attach the engine roll restrictor.
Tighten to 80 Nm
32. Tighten to 80 Nm.
33. Install the radiator splash shield.
For additional information, refer to:
Radiator Splash Shield
(501-02 Front
End Body Panels, Removal and Installation).
34. Install the front wheels and tires.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
35. Install the front muffler.
For additional information, refer to:
Front Muffler - 2.0L NA V6 -
AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
(309-00 Exhaust System,
Removal and Installation).
Vehicles with 2.5L or 3.0L engine
36. Carry out the front subframe alignment procedure.
For additional information, refer to:
Underbody Misalignment Check
(502-00 Uni-Body, Subframe and Mounting System, General Procedures).
Vehicles with stability assist
37. Calibrate the steering angle sensor, using the Jaguar approved
diagnostic system.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст