Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 638
13.
CAUTION: Do not connect the electrical connectors for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connectors.
14.
CAUTION: Do not connect the electrical connectors for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connectors.
15. Attach the parcel shelf trim panel.
16. Install the rear seat backrest latch covers.
17. Attach the seat belt reel trim panels.
18. Install the high level stop lamp. For additional information, refer to
Section
417-01 Exterior Lighting
.
19.
CAUTION: Make sure the windshield glass adhesive is set before
removing the protective tape.
Remove the protective tape from the top of the windshield glass.
Published: 11-May-2011
Glass, Frames and Mechanisms - Rear Window Glass Using Cutting Tool
Removal and Installation
Special Tool(s)
Lubricant concentrate
BTB-W K9L
Spray bottle
BTB-W K9
Cutting tool
BTB-W K10HD
Serrated general purpose 'Z' cutting blade
BTB-W K24ZSC
Cutting blade controller arm
BTB-W K11B
Reverse powered cold knife blade cutting tool
BTB-W K27RM
Pinchweld scraper blade
BTB-W K6
Removal
1. Remove the high level stop lamp. For additional information, refer to
Section
417-01 Exterior Lighting
.
2. Detach the seat belt reel trim panels.
3. Remove the rear seat backrest latch covers.
4. Detach the parcel shelf trim panel.
5. Disconnect the electrical connectors.
6. Disconnect the electrical connectors.
7. Disconnect the electrical connector.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст