Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 222
110. NOTE: Do not discard the crankshaft rear oil seal carrier.
Remove the crankshaft rear oil seal carrier.
111. Remove and discard the oil pan.
Remove the oil pan retaining nuts and bolts.
112. Remove the oil pump pickup tube.
Remove and discard the O-ring seal.
113. Remove the oil pump.
Remove the chain from the crankshaft sprocket.
114.
CAUTION: Remove the ladder frame bolts in the sequence
shown.
Remove the ladder frame.
Remove and discard the ladder frame gasket.
115. NOTE: One piston oil cooler jet shown, other piston oil cooler jets
similar.
Remove the piston oil cooler jets.
116.
CAUTION: Keep the connecting rod bearing caps in order for
installation.
Remove the connecting rod bearing caps.
117.
CAUTION: Match the piston and connecting rods to the
connecting rod caps.
Remove the pistons.
118.
CAUTION: Keep the crankshaft main bearing caps in order for
installation.
Remove the crankshaft main bearing caps.
119. Remove the crankshaft.
Published: 11-May-2011
Engine - 2.0L Duratorq-TDCi/2.2L Duratorq-TDCi (110kW/150PS) - Puma - Engine
Assembly
Special Tool(s)
Piston ring compressor
303-372
Universal Flange Holding Wrench
205-053
Adapter for 205-053
205-053-02
Bedplate alignment plate
303-1095
Remover/Installer Crankshaft Front Oil Seal
303-679
Aligner, Engine Front Cover
303-682
Timing Tool, Crankshaft
303-698
Aligner, Fuel Injector
303-711
Oil seal installer
308-417
Pointer, top dead center (TDC)
303-1094
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст