Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 188

29. Connect the right-hand catalyst monitor sensor electrical connector.

30. Install the right-hand catalytic converter retaining bolts.

Tighten to 25 Nm.

31. Install a new halfshaft snap ring.

32. Install a new halfshaft seal.

33.

CAUTION: Do not use excessive force when engaging the

halfshaft to the link shaft. Failure to follow this instruction may result in
damage to the component.

• NOTE: Make sure the halfshaft is fully located to the link shaft.

Install the halfshaft.

34. Install the transfer case Y bracket.

Tighten to 55 Nm.

35. Install the transfer case Y bracket retaining bolts.

Tighten to 25 Nm.

Vehicles with 2.0L engine

36. Install the halfshaft and intermediate shaft assembly.

Tighten to 20 Nm.

All vehicles

37.

CAUTION: Make sure the right-hand drive halfshaft is supported,

failure to follow this instruction may result in damage to the component.

Using the special tool, install the engine and transaxle to the subframe.

38. Install the engine roll restrictor.

Tighten to 80 Nm.

39. Install the engine roll restrictor retaining bolt.

Tighten to 80 Nm.

40. Remove the special tool.

41. Connect the power steering high-pressure pipe.

Install a new O-ring seal.

Tighten to 30 Nm.

42. Install the power steering high-pressure pipe retaining bolt.

Tighten to 25 Nm.

43. Install a new halfshaft snap ring.