Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 419
33. Using the engine support bracket lower the powertrain assembly
approximately 60 mm (2.36 inches) between the transaxle and transaxle
mount bracket.
34. Raise the vehicle.
35. Align the powertrain assembly jack to the transaxle.
Secure the transaxle to the powertrain assembly jack.
36. Remove the transaxle retaining bolts.
37. NOTE: Shown with the powertrain assembly jack removed for clarity.
Remove the transaxle retaining bolts.
38. Remove the transaxle.
Detach the transaxle from the clutch plate.
Lower the powertrain assembly jack and transaxle assembly.
Published: 11-May-2011
Manual Transmission/Transaxle - Transaxle2.2L Duratorq-TDCi (110kW/150PS) -
Puma
Removal
Special Tool(s)
Slide hammer
100-012
100-012-02
Slide hammer shaft
Halfshaft remover fork
204-226
Powertrain assembly jack
HTJ1200-2
Pinion oil seal remover
308-208
Engine support bracket
303-021
Removal
1. Remove the battery tray.
For additional information, refer to:
Battery Tray
(414-01 Battery,
Mounting and Cables, Removal and Installation).
2. Remove the front subframe.
For additional information, refer to:
Front Subframe - 2.0L Duratorq-
TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma
(502-00 Uni-Body,
Subframe and Mounting System, Removal and Installation).
3. Remove the charge air cooler intake pipe retaining bolts.
4.
CAUTION: Make sure the halfshaft constant velocity (CV) joints do
not over articulate. Failure to follow this instruction may result in damage
to the CV joints.
Detach the right-hand halfshaft.
Disengage the right-hand halfshaft from the transaxle.
Secure the right-hand halfshaft to one side.
5. NOTE: Plug the transaxle to prevent fluid loss or dirt ingress.
Using the special tool, remove the right-hand halfshaft seal.
6. Using the special tools, detach the left-hand halfshaft.
7.
CAUTION: Make sure the halfshaft CV joints do not over articulate.
Failure to follow this instruction may result in damage to the CV joints.
• NOTE: Secure the right-hand halfshaft using tie strap.
Support the left-hand halfshaft.
8. Remove and discard the left-hand halfshaft snap ring.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст