Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 448

13. Detach and reposition the radiator inlet coolant pipe.

14. Remove the catalytic converter heat shield.

15. Remove the catalytic converter.

Discard the retaining nuts.

16. Remove the HO2S.

17. Remove and discard the catalytic converter retaining studs.

18. Remove and discard the sealing ring.

Installation

1.

CAUTION: Never use jointing compound forward of the catalytic

converter.

To install, reverse the removal procedure.

Install a new sealing ring.

2. Install new catalytic converter retaining studs.

Tighten to 9 Nm.

3. Tighten to 40 Nm.

4. NOTE: Make sure that the retaining nuts are tightened twice in the
sequence shown.

Tighten in the sequence shown to 25 Nm.

5. Tighten to 10 Nm.

6. Tighten to 6 Nm.

7. Tighten to 10 Nm.

8. Tighten to 55 Nm.

9. NOTE: 2.5L and 3.0L shown, 2.0L similar.

Tighten to 55 Nm.

10. Tighten to 25 Nm.

11. NOTE: For NAS vehicles only.

If required, carry out a long drive cycle.
For additional information, refer to:

Powertrain Control Module (PCM)

Long Drive Cycle Self-Test

(303-14A Electronic Engine Controls - 2.0L NA

V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, General Procedures).

Была ли эта страница вам полезна?
Да!Нет
3 посетителя считают эту страницу полезной.
Большое спасибо!
Ваше мнение очень важно для нас.

Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.

Текст

Политика конфиденциальности