Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 634
1.
CAUTION: Use care when installing the sleeve and the pin into the
window glass. Failure to follow these instructions may result in damage to
the window glass.
Install the pin.
1.
CAUTION: Make sure the sleeve is fitted central in the
window glass.
1. Install the sleeve.
1.
CAUTION: Make sure the sleeve stays central in the
window glass.
2. Install the pin.
2. Install the window glass.
3. NOTE: Insert the glass into the regulator glass clamp and firmly pushed
down. Check both sides of the clamp have snapped over the spacer
bracket pin.
Attach the window glass into the regulator clamp.
4. Reposition the rear window guide rail.
5. Install the rear quarter window glass. For additional information, refer
to
Window Glass—Rear Quarter
.
Published: 11-May-2011
Glass, Frames and Mechanisms - Rear Door Window Regulator
Removal and Installation
Removal
1. Remove the door trim panel.
For additional information, refer to Section
501-05 Interior Trim and
Ornamentation
.
2. Remove the rear speaker.
For additional information, refer to Section
415-03 Speakers
.
3.
CAUTION: Do not touch the adhesive surface as rebonding will be
impaired
Peel back the weathershield.
4. Lower the door window glass until the pin is visible in the access hole.
5. Detach the window glass from the regulator.
1. Remove the pin.
2. Remove the sleeve.
3. Detach the window glass from the regulator.
6. Secure window glass in the fully raised position.
Apply suitable protective tape to the top of the window glass.
7. Remove the rear door window regulator.
Installation
1. Install the rear door window regulator.
Tighten to 7 Nm.
2.
CAUTION: Support the window glass prior to removal of the
protective tape.
Remove the protective tape from the top of the window glass.
3.
CAUTION: Use care when installing the sleeve and pin into the
window glass. Failure to follow these instructions may result in damage to
the window glass.
Install the pin.
3.
CAUTION: Make sure the sleeve is fitted central in the
window glass.
1. Install the sleeve.
3.
CAUTION: Make sure the sleeve stays central in the
window glass.
2. Install the pin.
4. NOTE: Insert the glass into the regulator glass clamp and firmly pushed
down. Check both sides of the clamp have snapped over the spacer
bracket pin.
Attach the window glass into the regulator clamp.
5.
CAUTION: Do not touch the adhesive surface as rebonding will be
impaired
Install the weathershield.
6. Install the rear door speaker.
For additional information, refer to Section
415-03 Speakers
.
7. Install the door trim panel.
For additional information, refer to Section
501-05 Interior Trim and
Ornamentation
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст