Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 433
5. Disconnect the gearshift selector cables.
6. NOTE: Right-hand shown, left hand similar.
Remove the center console right-hand side trim panel.
7. Remove the gearshift lever.
1. Remove the gearshift lever mounting retaining nuts.
2. Remove the gearshift lever.
Installation
1. Tighten to 60 lb-ft.
Published: 11-May-2011
Manual Transmission/Transaxle External Controls - Gearshift LeverVehicles With:
6-Speed Manual Transaxle - MMT6
Removal and Installation
Removal
1. Remove the gearshift lever knob.
Remove the gearshift lever spring.
2. Remove the restraints control module (RCM).
For additional information, refer to:
Restraints Control Module (RCM)
(501-20B Supplemental Restraint System, Removal and Installation).
3. Remove the floor console mounting bracket.
4. NOTE: Left -hand shown, right-hand similar.
Remove the floor console sound absorbing foam.
5. Disconnect the gearshift selector cables.
6. Detach the gearshift lever assembly to allow access to the gearshift
cables.
Remove the retaining nuts.
7. Disconnect the gearshift cables.
Remove the gearshift lever assembly.
Installation
1. Tighten to 10 Nm.
Published: 11-May-2011
Transfer Case -
Capacities
Description
Liters
Transfer case lubricant, drain and refill
0.50
Torque specifications
Description
Nm
Lb - ft
Lb - in
M8 pinion housing studs
35
26
-
M8 pinion housing bolts
35
26
-
Engine anti-roll restrictor mounting bracket top retaining bolts
55
41
-
Engine anti-roll restrictor mounting bracket side retaining bolts
35
26
-
Engine anti-roll restrictor mounting bracket bottom retaining nuts
35
26
-
Engine anti-roll restrictor mount retaining bolt
55
41
-
Transfer case support bracket top retaining bolts
25
18
-
Transfer case support bracket bottom retaining bolt
47
35
-
Transfer case retaining bolts*
80
59
-
Transfer case fill plug
20
15
-
Exhaust front pipe retaining clamp
55
41
-
Catalytic converter to catalytic converter mount bracket retaining bolts
25
18
-
Shock absorber and spring assembly securing nuts
25
18
-
*On vehicles prior to VIN J25640, if you are re-using fixings, tighten to 90 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст