Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 161

100. Using the special tool, remove and discard the link shaft oil seal.

All vehicles

101. Remove the starter motor.

102. Remove the dust cover.

103. Remove the access cover.

104. Remove the transaxle retaining bolts.

105. Remove the transaxle retaining bolts.

106. Remove the transaxle.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - EngineVehicles
With: 5-Speed Automatic Transaxle - JATCO/6-Speed Automatic Transaxle - AWF21

Removal

Special Tool(s)

Powertrain Assembly Jack

HTJ1200-2

5 Point Security Torx Bit

418-535

Ball joint splitter

204-192

W heel hub puller

205-491

Adaptor nuts

205-491-01

Forcing screw

204-269

Slide hammer

100-012

Slide hammer shaft

100-012-02

Halfshaft remover fork

204-226

Right-hand halfshaft splitter

307-442

Right-hand halfshaft splitter handle

307-443

Pinion oil seal remover

308-208

Link shaft limiting tool

307-446

Engine lifting kit

303-707

Removal

All vehicles

1. NOTE: Left-hand shown, right-hand similar.

Loosen the front hub retaining nuts.

2. Drain the transaxle.

For additional information, refer to:

Transmission Fluid Drain and Refill

(307-01B Automatic Transmission/Transaxle - Vehicles W ith: 6-Speed
Automatic Transaxle - AWF21, General Procedures).

3. Remove the steering column lower retaining bolt.

4. Remove the battery tray.

For additional information, refer to:

Battery Tray

(414-01 Battery,

Mounting and Cables, Removal and Installation).

5. Recover the air conditioning (A/C) refrigerant.