Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 649

Are any of the cables disconnected or damaged?
Yes

RECTIFY as necessary. For additional information, refer to removal and installation in this section.

No

CARRY OUT functional tests using the Jaguar approved diagnostic system.

Published: 11-May-2011

Handles, Locks, Latches and Entry Systems - Remote Transmitter Programming

General Procedures

1. NOTE: All remote transmitters are programmable and must be
programmed at the same time.

• NOTE: If an attempt is made to program a fifth remote transmitter after
four remote transmitters have already been programmed, the generic
electronic module (GEM) will exit the remote transmitter learn mode. If the
remote transmitter learn mode is entered again, the attempt shall erase
all remote entry device associations and start a new set of four remote
entry device associations with this fifth remote transmitter programming
attempt.

The complexity of the electronics involved with the remote keyless
entry, of which the GEM is a part, and the multiplexed communication
network which are connected to it, exclude the use of workshop general
electrical test equipment. Therefore, reference should be made to the
Jaguar Approved Diagnostic System for programming the remote
transmitters.

Published: 11-May-2011

Handles, Locks, Latches and Entry Systems - Exterior Front Door Handle

Removal and Installation

Removal

1. Remove the front door window glass.

For additional information, refer to:

Front Door Window Glass

(501-11

Glass, Frames and Mechanisms, Removal and Installation).

2. Remove the front door security shield.

1. Remove the retaining screw.

2. Remove and discard the retaining clips.

3. Remove the front door security shield.

3. Disconnect the front door exterior handle connecting rod and the door

lock cylinder connecting rod.

4. Remove the front door motor and window regulator upper and lower rear

securing scews.

5. Remove the front door exterior handle retaining screws.

6. Remove the front door exterior handle.

Installation

1. NOTE: Install new front door security shield retaining clips.

To install, reverse the removal procedure.

Tighten to 5 Nm.

2. Tighten to 7 Nm.