Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 469
8. NOTE: Non federal market vehicles only.
Remove the fuel pump module and crossover pipes.
Remove and discard the O-ring seal.
9. NOTE: Federal market vehicles only.
Remove the fuel tank.
For additional information, refer to:
Fuel Tank - 2.5L NA V6 - AJV6/3.0L
NA V6 - AJ27
(310-01 Fuel Tank and Lines, Removal and Installation).
10. NOTE: Federal market vehicles only.
Remove the fuel supply pipe.
For additional information, refer to:
Quick Release Coupling - Push
Connect
(310-00 Fuel System - General Information, General
Procedures).
11. NOTE: Federal market vehicles only.
Disconnect the electrical connector.
12. NOTE: Federal market vehicles only.
• NOTE: Note the orientation of the fuel pump module before removal.
Using the special tool, remove the locking ring.
13. NOTE: Federal market vehicles only.
Detach the fuel pump module flange from the fuel pump module base.
14. NOTE: Federal market vehicles only.
Disconnect the electrical connector.
15. NOTE: Federal market vehicles only.
Disconnect the electrical connector.
16. Detach the fuel crossover pipe from the fuel pump module base.
17. NOTE: Federal market vehicles only.
Disconnect the electrical connector.
18. NOTE: Federal market vehicles only.
Disconnect the fuel crossover pipe from the fuel pump module base.
19.
CAUTION: Make sure the float or arm are not damaged while
removing the fuel pump module.
• NOTE: Federal market vehicles only.
Remove the fuel pump module.
Remove the fuel pump module base from the fuel tank.
Installation
• W ARNINGS:
Place the vehicle in a quarantined area and arrange "No Smoking/Petrol Fumes" signs about the vehicle.
Before any work is carried out on the fuel system, ground the vehicle to earth and maintain the ground connection until the work is
complete.
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly
flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.
The fuel system remains pressurized for a long time after the ignition is switched off. The fuel pressure must be relieved before
attempting any repairs. Failure to follow these instructions may result in personal injury.
After carrying out repairs, the fuel system must be checked visually for leaks. Failure to follow these instructions may result in
personal injury.
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure
to follow these instructions may result in personal injury.
If taken internally do not induce vomiting, seek immediate medical attention. Failure to follow these instructions may result in
personal injury.
If fuel contacts the eyes, flush the eyes with cold water or eyewash solution and seek medical attention.
W ash hands thoroughly after handling, as prolonged contact may cause irritation. Should irritation develop, seek medical attention.
• NOTE: Federal market vehicles, refer to step 1.
• NOTE: Non federal market vehicles, refer to step 2.
1.
CAUTION: Make sure the float or arm are not damaged while
installing the fuel pump module.
• NOTE: Federal market vehicles only.
• NOTE: Make sure the fuel pump module is correctly orientated.
To install, reverse the removal procedure.
Install a new O-ring seal.
Tighten to 120 Nm.
2. CAUTIONS:
Make sure the float or arm are not damaged while installing the fuel
pump module.
Make sure the fuel cross over pipes are not damaged while installing
the fuel pump module.
• NOTE: Non federal market vehicles only.
• NOTE: Make sure the fuel pump module is correctly orientated.
To install, reverse the removal procedure.
Install a new O-ring seal.
Tighten to 70 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст