Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 549
Published: 11-May-2011
Exterior Lighting - Rear Lamp AssemblyWagon
Removal and Installation
Removal
1. Remove the loadspace trim panel.
For additional information, refer to:
Loadspace Trim Panel
(501-05
Interior Trim and Ornamentation, Removal and Installation).
2. Disconnect the rear lamp assembly electrical connector.
3. Remove the rear lamp assembly retaining nuts.
4. Detach the rear lamp assembly.
Press the tangs.
5. Remove the rear lamp assembly.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Interior Lighting - Interior Lighting
Description and Operation
The interior lighting system consists of the following components:
One front interior lamp.
Two map reading lamps.
Two front footwell lamps
One rear interior lamp.
Two front door/puddle lamps
One glove compartment lamp.
Two vanity mirror lamps.
One luggage compartment lamp on 4-door vehicles.
Two loadspace lamps on wagon.
The automatic operation of the interior lights is controlled by the general electronics module (GEM). Pressing the interior lamp switch in the
overhead console switches the interior lighting control from automatic to ON position. When the switch is in the ON position, if any of the
doors are open, only the rear interior lamp can be turned off.
If the rear interior lamp switch is in the AUTOMATIC position, the front interior lamp switch can operate the rear interior lamp.
In the AUTOMATIC position, when the interior lights have faded out, each lamp can be switched on or off by pressing the associated switch.
If the interior lamps are switched on and the ignition switch is turned to the OFF or ACCESSORY position, the lights will automatically turn
off after ten minutes.
With the switch in the AUTOMATIC position the following times apply to the interior lights fading out assuming lights on.
Condition
Fade out time
Open any door with key not in ignition, close door
Lamps will fade out after twenty seconds
Open any door with engine in RUN position, close door
Lamps will fade out immediately
Open any door, switch ignition to the RUN position, close door
Lamps will fade out immediately
Published: 11-May-2011
Interior Lighting - Interior Lighting
Diagnosis and Testing
1. Verify the customer concern.
1.
2. Visually inspect for obvious signs of mechanical or electrical damage.
2.
Visual Inspection Chart
Mechanical
Electrical
Door switch(s)
Interior lamp switch(s)
Electrical connector(s)
Wiring harness for damage or corrosion
Bulb(s)
Fuse(s)
General electronics module(GEM)
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next
step.
3.
4. If the cause is not visually evident, verify the symptom and refer to the Jaguar Approved Diagnostic System.
4.
Published: 11-May-2011
Interior Lighting - Front Interior Lamp
Removal and Installation
1. Remove the overhead console. For additional information, refer to
Section
501-12 Instrument Panel and Console
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст