Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 533
Published: 11-May-2011
Generator and Regulator - Generator2.0L Duratorq-TDCi/2.2L Duratorq-TDCi
(110kW/150PS) - Puma
Removal and Installation
Special Tool(s)
Separator, ball joint
204-192
Release tool, belt tensioner
303-676
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables, General Procedures).
2. Remove the air deflector.
For additional information, refer to:
Air Deflector - 2.0L Duratorq-
TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma
(501-02 Front End Body
Panels, Removal and Installation).
3. Remove the front, right-hand wheel and tire.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
4. Remove the right-hand wheel arch liner access cover.
5. Remove the tie-rod end retaining nut.
6. NOTE: W hen the tie-rod end is separated from the wheel hub assembly,
the ball joint seal should be protected to prevent damage.
Using the special tool, detach the tie-rod end.
7. Detach the right-hand stabilizer bar link.
Reposition the anti-lock brake system (ABS) wiring harness
mounting bracket.
8. Using the special tool, detach the accessory drive belt.
9. Remove the generator cooling duct from the generator.
10. Detach the generator positive cable.
11. Disconnect the generator electrical connector.
12. Remove the generator upper retaining bolt.
13. Remove the generator retaining nuts.
14. Remove the generator mounting studs.
15. Remove the generator.
Installation
1. Install the generator.
2. Install the generator mounting studs.
Tighten to 15 Nm.
3. Loosely install the generator retaining nuts.
4. Install the generator upper retaining bolt.
1. Tighten to 47 Nm.
5. Tighten to 47 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст