Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 675
Published: 11-May-2011
Safety Belt System - Rear Safety Belt Buckle
Removal and Installation
Removal
1. Remove the rear seat cushion for additional information, refer to
Section
501-10 Seating
.
2. Remove the left-hand rear safety belt buckles.
Remove the retaining bolt.
3. Remove the right-hand rear safety belt and buckle.
Remove the retaining bolt.
Installation
1. To install reverse the removal procedure.
• NOTE: Make sure the anti rotation pins on the body and safety belt
anchor plate are located correctly before tightening the bolt.
Tighten to 55 Nm.
2. NOTE: Make sure the anti rotation pins on the body and safety belt
anchor plate are located correctly before tightening the bolt.
Tighten to 55 Nm.
Published: 11-May-2011
Safety Belt System - Rear Safety Belt Retractor4-Door
Removal and Installation
Removal
• NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part
and carry out the diagnostic procedure again.
1. Remove the rear seat backrest for additional information, refer to
Section
501-10 Seating
.
2. NOTE: Left-hand shown right-hand similar.
Remove the rear safety belt anchor retaining bolt.
3. Remove and detach the rear safety belt upper trim cover.
4. Remove the rear safety belt retractor trim panel.
5. Remove the rear safety belt retractor assembly.
Remove the retaining bolt.
Installation
• NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part
and carry out the diagnostic procedure again.
1. To install reverse the removal procedure.
Tighten to 55 Nm.
2. Tighten to 55 Nm.
Published: 11-May-2011
Safety Belt System - Rear Safety Belt RetractorWagon
Removal and Installation
Removal
1. Remove the loadspace trim panel.
For additional information, refer to:
Loadspace Trim Panel
(501-05
Interior Trim and Ornamentation, Removal and Installation).
2. Remove the rear seat bolster.
For additional information, refer to:
Rear Seat Bolster - Wagon
(501-10
Seating, Removal and Installation).
3. Remove the rear safety belt anchor retaining bolt.
4. Remove the rear safety belt retractor retaining bolt.
5. Remove the rear safety belt retractor.
Installation
1. To install reverse the removal procedure.
Tighten to 55 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст