Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 436
29. Attach the engine roll restrictor.
Tighten to 80 Nm.
30.
W ARNING: Do not work on or under a vehicle supported only by a
jack. Always support the vehicle on safety stands.
• NOTE: The lower lip of the sill must be 540mm from the floor.
Raise and support the left hand side of the vehicle.
Remove the vehicle from the lift.
Raise the vehicle using two jacks.
31. Fill the transfer case with 400ml of oil.
Tighten the filler plug to 20Nm.
Published: 11-May-2011
Transfer Case - Halfshaft Seal RH
In-vehicle Repair
Removal
1. Remove the right-hand halfshaft seal.
For additional information, refer to
Transfer Case
in this section.
Published: 11-May-2011
Transfer Case - Transfer Case Rear Output Shaft Seal
In-vehicle Repair
Special Tool(s)
Flange holding tool
205-053
Flange remover/installer
204-068A
Flange remover/installer boss
204-266
Flange remover/installer
204-295
Seal extractor
308-375
Slide hammer
100-012
Slide hammer adapter
100-012-01
Removal
1.
W ARNING: Do not work on or under a vehicle supported only by a
jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. NOTE: Mark the position of the driveshaft in relation to the drive pinion
flange.
Remove two opposing driveshaft universal joint retaining bolts.
3. Loosen the remaining driveshaft universal joint retaining bolts.
4. Detach the engine roll restrictor.
Remove the engine roll restrictor retaining bolt.
5. Detach the driveshaft from drive pinion flange.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст