Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 29
Published: 11-May-2011
Front Suspension - Shock Absorber and Spring Assembly
Removal and Installation
Special Tool(s)
Separator, Ball Joint
204-192 (JD-219)
Powertrain Assembly Jack
HTJ1200-2
W heel hub puller
205-491
Adapter nuts
205-491-01
Forcing screw
204-269
Knuckle splitter
204-159
Removal
All vehicles
1. Loosen the wheel hub nut.
2. Remove the wheel and tire.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
3. Detach the brake hose retaining bracket.
4. Detach the stabilizer link bar.
5. Disconnect the front wheel speed sensor electrical connector.
6.
CAUTION: Secure the brake caliper and anchor plate assembly to
one side.
Remove the brake caliper and anchor plate assembly.
7. Remove the tie-rod end retaining nut.
8. NOTE: W hen the tie-rod end is separated from the wheel hub assembly,
the ball joint seal should be protected to prevent damage.
Using the special tool, detach the tie-rod end.
Vehicles with high intensity discharge headlamps
9. Detach the link rod from the headlamp leveling sensor.
All vehicles
10. Install the special tool.
11. NOTE: Left-hand shown, right-hand similar.
Position and adjust the special tool rear height adjuster.
12. NOTE: Left-hand shown, right-hand similar.
Remove the front subframe reinforcement plate retaining bolts.
13. NOTE: Left-hand shown, right-hand similar.
Remove the front subframe rear mount retaining bolts.
14. Using the special tool, lower the front subframe to a maximum of 30
mm (1.18 inches).
15. Remove and discard the wheel hub nut.
16. Using special tools, detach the halfshaft.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст