Jaguar XJ (X350). Service manual — part 1221
8 . Lower the vehicle.
9 . NOTE:
Vehicles with supercharger shown, vehicles without supercharger similar.
Using the special tool, lower the engine.
1) Adjust the engine support beam.
2) Lower the engine.
10 . Raise the vehicle.
11 . Install the left-hand engine mounting lower retaining nut.
Tighten to 63 Nm.
Left-hand drive vehicles
12 .
CAUTION: The steering gear must be supported at all times.
Detach the steering gear.
Remove and discard the tie straps.
13 .
CAUTION: The steering gear must be supported at all times.
Attach the steering gear.
www.
Tighten to 100 Nm.
14 . Install the steering gear shaft pinch bolt.
Tighten to 35 Nm.
All vehicles
15 . Install the left-hand front wheel and tire assembly.
For additional information, refer to Wheel and Tire (74.20.05)
16 . Install the air deflector.
For additional information, refer to Air Deflector (76.11.41)
17 . NOTE:
Vehicles without supercharger shown, vehicles with supercharger similar.
Remove the special tool.
18 . NOTE:
Vehicles without supercharger shown, vehicles with supercharger similar.
Remove the special tools.
Vehicles without supercharger
19
.
Install the throttle body.
For additional information, refer to Throttle Body - 4.2L NA V8 - AJV8/3.5L NA V8 - AJV8, VIN
Range: G45704->G99999 (19.70.04)
All vehicles
20
.
Attach the accessory drive belt.
1) Rotate the accessory drive belt tensioner counter-clockwise.
Use a 3/8 inch square drive bar to rotate the accessory drive belt
tensioner.
2) Attach the accessory drive belt.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст