Jaguar XJ (X350). Service manual — part 1034
Manifold Absolute Pressure (MAP) Sensor
(18.30.86)
Removal
1 . Remove the oil filler cap.
2 . Remove the engine cover.
3 . Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
4 . Remove the MAP sensor.
Installation
1 . To install, reverse the removal procedure.
Tighten to 3 Nm.
www.
Mass Air Flow (MAF) Sensor (18.30.15)
Removal
NOTE:
This procedure is showing the lower mass air flow (MAF) sensor removal and installation. The
upper MAF sensor removal and installation is similar.
1 . Remove the air cleaner.
For additional information, refer to
2 . Remove the mass air flow (MAF) sensor.
Installation
1 . To install, reverse the removal procedure.
Tighten MAF sensor retaining screws to 2 Nm.
Oil Temperature Sensor (18.31.01)
Removal
1 . Remove the air deflector.
For additional information, refer to Air Deflector (76.11.41)
2 . Drain the engine oil.
Place suitable container under the vehicle.
Remove the drain plug and drain the engine oil.
Install the drain plug.
Tighten to 25 Nm.
3 . Disconnect the oil temperature sensor electrical connector.
4 . Remove the oil temperature sensor.
Remove and discard the O-ring seal.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст