Jaguar XJ (X350). Service manual — part 489

96 . Detach the engine wiring harness retaining clips.

97 . Remove the engine wiring harness

98 . Remove the noise and vibration insulating pad.

99 . Remove the intake manifold heater coolant hose.

4. Remove the knock sensors.

5. Remove the intake manifold heater coolant hose.

100 . Remove the engine block insulation grommet.

101 . Remove the water pump pulley.

•

Using the special tool, retain the water pump pulley.

102 . Remove the water pump.

•

Remove and discard the gasket.

•

Remove and discard the O-ring seal.

www.

103 . Remove the thermostat housing.

•

Remove and discard the O-ring seals.

104 . NOTE:

Left-hand shown, right-hand similar

Remove the ignition coils.

105 . Remove the spark plugs.

106 . Remove the right-hand camshaft position (CMP) sensor.

•

Remove and discard the O-ring seal.

107 . Remove the left-hand camshaft position (CMP) sensor.

•

Remove and discard the O-ring seal.

108

.

CAUTION: Under no circumstances should the crankshaft setting peg 303-645 be

used in the following operations to lock the crankshaft.

NOTE:

The crankshaft retaining bolt will be very tight.

Using special tools, retain the crankshaft pulley.

•

Remove and discard the crankshaft pulley bolt.

www.