Jaguar XJ (X350). Service manual — part 1041
Fluid Pump
Item
Part Number
Description
1
Fluid pump housing
2
Intermediate plate
3
Centring plate
4
Stator shaft
5
Intake port
6
To mesh filter
7
Seal
8
Bearing
9
Retaining clip
10
Shaft seal
11
Impeller
12
Ring gear
Fluid Pan, Gasket and Filter
The transmission fluid pan, gasket and filter is a one piece assembly, all transmission fluid is drawn
from the transmission fluid pan by the fluid pump and passes through the fluid filter.
Transmission Control Module (TCM) and Main Control Valve Body
Electrostatic Discharge (ESD)
CAUTION: When working with the transmission control module (TCM) and main control
valve body, all suitable safety precautions must be taken to protect the component against
electrostatic discharge (ESD). Failure to follow these instructions may result in component damage.
Make sure all possible safety precautions are taken to protect the TCM and main control valve body
unit against ESD.
Personal Wrist-Band Earthing
Earthing (grounding) by means of a wrist band or strap is the most reliable method of diverting
electrostatic charges away from working personnel, and should therefore be used wherever possible,
particularly if the person concerned is working while seated. The wrist band earthing (grounding)
device consists of a bracelet closely attached to the wrist and a spiral earthing (grounding) cable
connecting it to the earthing (grounding) contact point. This system must include a quick-release
device so that the wrist can be released in the event of danger.
Shoes and Foot Earthing Straps
Electrically conductive shoes should be worn by persons who mainly work standing up or either
standing or sitting in ESD protection zones, particularly if wrist band earthing (grounding) is
impracticable. The standard calls for ESD shoes to record values between 0 and 35 Megga-ohms
(MOhm) resistance. However, for antistatic working shoes resistance values between 0.1 and 1000
www.
MOhm are called for, and a through-conducting resistance for protective shoes of 0.1 to 100 MOhm.
A lower limit value of not less than 0.1 MOhm must be maintained on account of the contact voltage
risk. For this reason the minimum value has been set contrary to the standard at the higher figure of
0.75 MOhm.
Transmission Control Module (TCM) and Main Control Valve Body
The transmission control module (TCM) and main control valve body is a combination of hydraulic
and electronic control units. Both these modules are installed in the transmission, in the fluid pan.
This technical principle has the following advantages:
Minimum tolerances (TCM is mated to solenoids)
Better coordination of gear shifts
Increased refinement
Optimized shift quality
Good reliability, since the number of plug connections and interfaces is reduced.
Transmission Control Module (TCM) and Main Control Valve Body
Item
Part Number
Description
1
TCM
2
Output speed sensor
3
Transmission fluid temperature sensor
4
Position switch
5
Pressure regulator 6
6
Solenoid valve
7
Pressure regulator 5
8
Pressure regulator 4
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст