Jaguar XJ (X350). Service manual — part 768
G552799t11 : CHECK THE GLOW PLUG OUTPUT CIRCUITS FOR HIGH
RESISTANCE
1. Measure the resistance between:
EC74, harness side EC76, harness side
Pin 01
Pin 01
Pin 02
Pin 02
Pin 03
Pin 03
EC74, harness side EC77, harness side
Pin 04
Pin 01
Pin 05
Pin 02
Pin 06
Pin 03
Is the resistance less than 10 ohms?
-> Yes
If DTCs P0380 or P0382 are logged and the tests above have not identified a circuit fault, a control
module may be at fault.
-> No
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams. Clear the
DTC, test the system for normal operation.
Removal and installation
Glow Plugs
Removal
1 . Remove the intake air shutoff throttle.
For additional information, refer to Intake Air Shutoff Throttle
2 . Remove the crankcase vent oil separator.
For additional information, refer to Crankcase Vent Oil Separator
3
.
NOTE:
Remove and discard the O-ring seal.
Remove the oil filter element housing.
Rotate the oil filter element housing five complete turns counter-
clockwise.
Allow the engine oil to drain from the oil filter element housing for two
minutes.
Remove the oil filter element housing.
4 . Detach the right-hand glow plug electrical connector.
www.
5 . Detach the left-hand glow plug electrical connector.
6 . Remove the right-hand bank glow plugs.
7 . Remove the left-hand bank glow plugs.
Installation
1
.
NOTE:
Make sure glow plug electrical connector is correctly fitted to all glow plugs on the left-
hand bank.
To install, reverse the removal procedure.
Tighten to 10 Nm.
2
.
NOTE:
Make sure glow plug electrical connector is correctly fitted to all glow plugs on the right-
hand bank.
Tighten to 10 Nm.
3 . NOTE:
Install a new O-ring seal.
Tighten to 25 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст