Jaguar XJ (X350). Service manual — part 172
NOTE:
To prevent the loss of brake fluid, apply the brake pedal hold-down tool and adjust to
hold the brake pedal down 40 mm (1.6 in).
NOTE:
Left-hand shown, right-hand similar.
Detach the brake hose.
Remove and discard the sealing washers.
4 . NOTE:
Left-hand shown, right-hand similar.
Remove the brake caliper retaining bolt dust covers.
5 . NOTE:
Left-hand shown, right-hand similar.
Remove the brake caliper retaining bolts.
6 . NOTE:
Left-hand shown, right-hand similar.
Remove the brake caliper.
7
.
CAUTION: Do not allow the brake caliper to hang on the hydraulic hose, as this will
damage the hose. Failure to follow this instruction will result in damage to the hose.
NOTE:
Left-hand shown, right-hand similar.
Remove the brake pad from the caliper piston.
8 . NOTE:
Left-hand shown, right-hand similar.
Remove the brake pad.
www.
Installation
1 .
WARNING: Do not use compressed air to disperse brake dust into the atmosphere.
CAUTION: Brake pads must always be replaced in axle sets.
CAUTION: Make sure the brake disc faces are clean before installation.
NOTE:
Left-hand shown, right-hand similar.
Install the brake pad.
Using a suitable tool, fully retract the brake caliper piston.
2 . NOTE:
Make sure the brake pad is correctly installed to the caliper piston.
NOTE:
Left-hand shown, right-hand similar.
Install the brake pad to the caliper piston.
3 . NOTE:
Left-hand shown, right-hand similar.
Install the brake caliper.
4 . NOTE:
Left-hand shown, right-hand similar.
Install the brake caliper retaining bolts.
Tighten to 58 Nm.
5 . NOTE:
Left-hand shown, right-hand similar.
Install the brake caliper retaining bolt dust covers.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст