Jaguar XJ (X350). Service manual — part 1411
1
.
CAUTION: Make sure the hood does not contact the vehicle body while
installing. Failure to carry out these instructions may cause damage to the
vehicle.
NOTE:
Left-hand shown, right-hand similar.
To install, reverse the removal procedure.
Tighten to 25 Nm.
2 . Align the hood.
For additional information, refer to
Installation
Door Check Arm – Armoured
Removal
NOTE:
Rear door check arm shown, front door check arm similar.
1 . Remove the rear door trim panel.
For additional information, refer to
Rear Door Trim Panel (76.34.04)
2 . Remove the rear door inner weather strip.
3 . Remove the rear door latch trim panel.
Remove the retaining screw.
4 . Using a suitable tool, cut the rear door panel seal.
Published: Mar 28, 2014
Vehicles
www.
5 . Disconnect the rear door speaker electrical connector.
6 . Remove the rear door speaker.
7 . Remove the rear door access panel.
Remove the retaining bolts.
8 . Remove the rear door handle release cable access panel.
9 . Remove the rear door armour panel.
10 . Remove the door check arm retaining bolt.
11 . Remove the door check arm.
Remove the retaining circlip and the retaining pin.
Installation
1 . Install the door check arm.
Install the retaining circlip and the retaining pin.
2 . Install the door check arm retaining bolt.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст