Jaguar XJ (X350). Service manual — part 506
94 . Install the spark plugs.
•
Tighten to 27 Nm.
95 . Install the left-hand camshaft position (CMP) sensor.
•
Install a new O-ring seal.
•
Tighten to 7 Nm.
96 . Install the right-hand camshaft position (CMP) sensor.
•
Install a new O-ring seal.
•
Tighten to 7 Nm.
97 . NOTE:
Left-hand shown, right-hand similar
Install the ignition coils.
•
Tighten to 5 Nm.
98 . Install the thermostat housing.
•
Install new O-ring seals.
•
Tighten to 10 Nm.
www.
99 . Install the water pump.
•
Install new O-ring seals and gaskets.
•
Tighten to 12 Nm.
100 . Install the water pump pulley.
•
Using special tool, retain the water pump pulley.
•
Tighten to 10 Nm + 45°.
101 . Install the engine block insulation grommet.
102 . Install the intake manifold heater coolant hose.
28. Install the knock sensors.
•
Tighten to 20 Nm.
29. Install the intake manifold heater coolant hose.
103 . Install the noise and vibration insulating pad.
104 . Install the engine wiring harness.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст