JAC Pick-Up. Service manual — part 5
Air Conditioner
Fan Switch
0 - Power off.
1 - Low-speed.
2 - Low/Middle Speed
3 - Middle/High Speed
4 - High speed
A/C Switching Button
Operate this button to run the
compressor when the fan switch is
turned to position 1, where the in-
built LED will illuminate. Press it a鄄
gain to disengage the compressor.
Refrigerant
Note R134a refrigerant is re鄄
quired for this air conditioning
system where necessary.
Containers
Glove Compartment
Pulling out the handle can open
the glove compartment.
The ignition key can lock and un鄄
lock the glove compartment.
1 -32
OWNER爷S MANUAL
pick-up
Utility Box
The utility box consists of two
storing spaces.
Interior Lighting
Map Light
Hit the switch to turn on the map
light and improve interior lighting
at night.
Coin Box
Coin Box
Receiving pocket money.
1 -33
Switch
Switch
Van Lock
Van Lock
To lock/unlock the van as shown.
Hood Release Rod
Hood Release Rod
To open the hood, you have to
pull the release rod located on
the left of the instrument panel to
unlock the unit and activate the
spring -loaded stay -on rod,
thereby opening and keeping the
hood at a certain angle, where
the engagement between the
end of the stay-on rod and the
hood is full engaged. To close
the hood, you have to retract
the stay-on rod into its clamp鄄
ing case to lay down the hood
and lock it at specified location.
1 -35
Ashtray
Ashtray
Make sure to push the ashtray
back after smoking. This can
avoid possible fire risk due to
an
unextinguished
cigarette
butt.
You can use the ashtray to
smoke by simply pulling it out.
Press the ashtray down and pull
it out further in case of cleaning.
Cigarette Lighter
Cigarette Lighter
To use the cigarette lighter, press
the resistance-wire plug and it can
eject automatically when ready. It in鄄
dicates some failure present if the
lighter fails to eject within 18 sec鄄
onds. In this case you must pull it
back to its original position manually.
* The socket for the cigarette
lighter can not be used for other
purposes so as to avoid nay pos鄄
sible circuit failures.
On-Board Charger
On-board Charger
You can charge your appliances
with dedicated charging unit for
ease of your trip.
1 -34
OWNER爷S MANUAL
pick-up
Problems
Causes and Solutions
No Power
Examine for any blown power fuses and replace them
where applicable.
Faulty LCD Display and In鄄
operative Buttons
Press RES Button.
Unable to Receive Stations.
Examine and ensure the antenna or its cable has been
properly fitted.
Poor
Receiving
Perfor鄄
mance
(1) The antenna has not extended to its full length and ex鄄
amine whether the antenna is broken or fully extended. If
broken, please replace it.
(2) Poor radio signal
(3) Poor antenna grounding. Examine whether the antenna
has been properly grounded.
Poor Vibration Resistance
Laser head is dusty and requires a cleaning.
Unable to insert a disk
A disk has already been loaded.
"STOO" Stereo Indicator
Flashes.
(1) Accurately tuned radio frequency.
(2) Poor radio signal (MONO mode is recommended)
CD Player
CD Player
Features:
CD/CD-R/CD-RW Compliant
FM/AM Receive
RCA Audio Output
Automatic Storage for up to 30
Radio Stations
Strong Vibration -free Electronic
System
4 伊45 W High -power Speaker
Output
DC12V Power Supply
Brief Troubleshooting Guide
Note: Please contact your professional service provider if these instructions fail
and no unauthorized repairs are allowed.
1 -37
Fuel Filler Cap
Fuel Filler Cap Release
Handle
Lift the oil filler cap release han鄄
dle at the side of the driver's
seat to open the filler cap, and
allowing oil filling without step鄄
ping off your car.
Antenna
Antenna
A telescopic antenna has better
receiving effect.
Aluminum Hub
Aluminum Hub
Aluminum hubs are provided.
1 -36
OWNER爷S MANUAL
pick-up
First 1500KM and After
Good break-in at the initial stage
will benefit fuel consumption, ex鄄
tend your vehicle's service life and
reduce the environmental pollution.
Break-in:
At the initial driving stage, the
engine will experience more wear
than any other moving parts. The
effect mainly depends on the first
1500KM.
First 1000KM
From experience:
1. Avoid full throttle operation
2 Do not exceed 3/4 of top en鄄
gine speed
3. Avoid high-speed operation.
4. Avoid operation with a trailer
as much as possible.
Caution:
New tires are also subject to "bre-
ak -in" as no optimal adhesion is
available at the beginning.
You have to pay attention to this
case for the first 100km.
New brake disks must go through
"break-in".
An optimal fiction effect can not be
attained until the first 200km has
passed. Slightly-degraded braking
can be compensated with more
braking effort, in a similar way to
newly-fitted disks.
From 1000KM to 1500 KM
You can gradually increase your
speed until it reaches the maxi鄄
mum vehicle speed or the maxi鄄
mum allowed engine speed.
In case of a cold start, run your
engine at high speed under no
circumstances either in the neural
position or any engaged position.
All speed related requirements
applies to a warm engine.
Avoid unnecessary high -speed
operation - an early selection of
high-speed gear will benefit fuel
consumption, noise reduction and
environmental protection.
Do not run your engine at exces鄄
sively low speed. Shift to low -
speed gear in case of non -
smooth engine running.
After Break-in
The maximum engine speed shall
be restricted before the pointer
reaches the red area on your
tachometer (if fitted).
2 -01
Dear User:
This manual covers JAC pick-ups listed in following table, where figures and notes are only applicable to the specified
model.
NAME
MODEL
JAC Pick-up
HFC1027K1R
JAC Pick-up
HFC1027E1R
ENGINE
HFC4DA1-1 Diesel
HFC4GA3 Petrol (*)
GEARBOX
END MARKER
LC5T80
LC5T80
Have a Nice Drive!
1
OWNER爷S MANUAL
pick-up
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст