Chery Tiggo 5 (T21). Service manual — part 450
40–
11
40
Installation
Installation is in the reverse order of removal.
HINT:
When installing the reversing radar sensor, align the boss at
the end of reversing radar sensor with the groove on rear
bumper assembly, and then firmly install the reversing radar
sensor as shown in the illustration.
RT21400030
CAUTION
Install connector in place when installing the reversing radar sensor.
Check reversing radar system for proper operation after installing the reversing radar sensor.
40–
12
40
Rear View Monitor Camera
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the Back Door Protector Assembly (
).
HINT:
The rear view monitor camera connector (arrow) has
been disconnected when removing the luggage
compartment upper trim assembly.
4. Remove the rear view monitor camera.
a. Remove 2 fixing screws (arrow) from the rear view
monitor camera, and remove the rear view monitor
camera.
(Tightening torque: 6 ± 0.1 N·m)
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when removing the rear view monitor
camera.
Appropriate force should be applied when removing the rear view monitor camera. Be careful not to
operate roughly.
RT21370260
RT21400040
CAUTION
Tighten fixing screws to specified torque when installing the rear view monitor camera.
Install connector in place when installing the rear view monitor camera.
Check reversing radar system for proper operation after installing the rear view monitor camera.
40–
13
40
Reversing Radar Control Module Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the C-pillar lower protector assembly (
).
4. Remove the C-pillar upper protector assembly (
5. Remove the reversing radar control module assembly.
a. Disconnect the reversing radar control module
assembly connector (1).
b. Remove 2 fixing bolts (arrow) between reversing
radar control module assembly and body, and remove
the reversing radar control module assembly.
(Tightening torque: 5 ± 1 N·m)
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when removing the reversing radar
control module assembly.
Appropriate force should be applied when removing the reversing radar control module assembly. Be
careful not to operate roughly.
1
RT21400050
CAUTION
Tighten fixing bolts to specified torque when installing the reversing radar control module assembly.
Install connector in place when installing the reversing radar control module assembly.
Check reversing radar system for proper operation after installing the reversing radar control module
assembly.
40–
14
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст