Chery Tiggo 5 (T21). Service manual — part 142
10–
14
10
Air Filter Element
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the air filter element.
a. Loosen the worm clamp (arrow) and disconnect the
connection between rear intake hose and hot wire air
flow meter.
(Tightening torque: 5 ± 0.5 N·m)
b. Disconnect the hot wire air flow meter connector (1).
c. Move the inlet pipe II assembly (1) and fuel vapor tube
III assembly (2) from the pipe clamp on the air filter
upper housing.
d. Remove 2 coupling screws (arrow) between air filter
upper housing and lower housing.
(Tightening torque: 1.3 ± 0.2 N·m)
e. Remove the air filter upper housing.
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
RT21100090
1
1
2
RT21100100
RT21100110
10–
15
10
f. Take out the air filter element.
Installation
1. Clean air filter upper housing and lower housing.
2. Install a new air filter element.
3. Other installation procedures are in the reverse order of removal.
RT21100120
ENVIRONMENTAL PROTECTION
Unneeded air filter element should be handled by the specialized department according to local laws and
regulations. Never discard it at will.
10–
16
10
Air Induction Pipe Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the air induction pipe assembly.
a. Remove 2 fixing bolts (arrow) from the air induction
pipe assembly.
(Tightening torque: 7 ± 1 N·m)
b. Remove the air induction pipe assembly from the air filter assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
RT21100130
10–
17
10
Air Filter Assembly & Bracket
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the air induction pipe assembly.
a. Remove 2 fixing bolts (arrow) from the air induction
pipe assembly.
(Tightening torque: 7 ± 1 N·m)
b. Remove the air induction pipe assembly.
4. Remove the air filter assembly.
a. Loosen the worm clamp (arrow) and disconnect the
connection between rear intake hose and hot wire air
flow meter.
(Tightening torque: 5 ± 0.5 N·m)
b. Disconnect the hot wire air flow meter connector (1).
c. Move the inlet pipe II assembly (1) and canister
solenoid valve inlet pipe (2) from the bracket on air
filter upper housing.
CAUTION
Be sure to wear necessary safety equipment when repairing to prevent accidents.
Try to prevent body paint surface from being scratched during removal and installation.
RT21100130
RT21100090
1
1
2
RT21100100
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст