Chery Tiggo 5 (T21). Service manual — part 248
22–
8
22
DIAGNOSIS & TESTING
Problem Symptoms Table
HINT:
Use the table below to help determine the cause of problem symptoms. Check each suspected area in
sequence. Repair or replace the faulty components, or adjust as necessary.
Symptom
Suspected Area
See page
Pulls
Tire (worn or improperly inflated)
Front wheel alignment (wrong)
Rear wheel alignment (wrong)
Front hub bearing (loose or worn)
Rear hub bearing (loose or worn)
Steering gear (misaligned or damaged)
Suspension component (worn)
Front wheel shimmy
Tire (worn or improperly inflated)
Wheel (imbalanced)
Front shock absorber assembly (stuck or
damaged)
Front wheel alignment (wrong)
Control arm assembly ball pin (stuck or
damaged)
Front hub bearing (loose or worn)
Steering gear (misaligned or damaged)
Rear wheel shimmy
Tire (worn or improperly inflated)
Wheel (imbalanced)
Rear shock absorber assembly (stuck or
damaged)
Rear hub bearing (loose or worn)
Rear wheel alignment (wrong)
22–
9
22
ON-VEHICLE SERVICE
Front Hub Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the front left wheel (
2. Remove the front drive shaft assembly locking nut.
a. Using a nut chisel and a hammer, loosen the staked
part of nut.
b. Remove the front drive shaft assembly locking nut
(arrow) while applying the brakes securely.
(Tightening torque: 300 ± 20 N·m)
WARNING
Be sure to wear necessary safety equipment to prevent accidents.
Check if safety lock of lifter is locked when repairing chassis parts.
It is not permitted to weld or modify bearing parts of wheel suspension and guide parts of wheel.
When removing chassis parts, replace the self-locking nuts and rusted nuts for safety.
RT21220050
CAUTION
Loosen staked part of nut completely, otherwise it will damage the thread of drive shaft assembly.
RT21220060
22–
10
22
3. Remove the front left brake caliper assembly (
).
4. Remove the front left brake disc (
).
5. Remove the front left hub assembly.
a. Remove 4 coupling bolts (arrow) between front left hub
assembly and front left steering knuckle assembly.
(Tightening torque: 70 - 75 N·m)
b. Remove the front left mudguard (arrow) and front left
hub assembly (1).
6. Remove the front left hub bearing.
a. Place front left hub assembly on a hydraulic press,
install bearing remover and adapter, and press out the
front left hub with hydraulic press.
CAUTION
Place front brake caliper assembly to a proper position after removal. Be careful not to extend front brake
hose excessively.
RT21220070
1
RT21220080
RT21220090
22–
11
22
b. Remove the front left hub bearing.
Installation
Installation is in the reverse order of removal.
RT21220100
CAUTION
Always tighten coupling bolts and nut to the specified torque.
Check that hub assembly turns freely without sticking after installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст