Chery Tiggo 5 (T21). Service manual — part 413
36–
35
36
Rear Washer Nozzle Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the back door protector assembly (
).
4. Remove the rear spoiler assembly (
).
5. Remove the rear washer nozzle assembly.
a. Disconnect the joint (arrow) between washer line and
rear washer nozzle assembly.
b. As shown in the illustration, press the rear washer
nozzle assembly claws (arrow) and remove the rear
washer nozzle assembly.
Inspection
1. Check rear washer nozzle assembly.
a. Check rear washer nozzle assembly for blockage,
deformation or damage. Replace rear washer nozzle
if necessary.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear washer nozzle assembly.
Appropriate force should be applied when removing rear washer nozzle assembly. Be careful not to
operate roughly.
RT21360220
RT21360230
RT21360240
36–
36
36
Installation
Installation is in the reverse order of removal.
CAUTION
Always operate carefully to prevent components from being damaged when installing rear washer nozzle
assembly.
Install washer line joint in place when installing rear washer nozzle assembly.
Check rear washer nozzle for proper operation after installing rear washer nozzle assembly.
36–
37
36
Washer Pump Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front bumper assembly (
).
4. Remove the front/rear washer pump assembly.
a. Disconnect the front washer pump connector (1) and
rear washer pump connector (2).
b. Disconnect the joint (3) between washer line and front
washer pump, and the joint (4) between washer line
and rear washer pump.
c. Using a screwdriver wrapped with protective tape,
remove the front washer pump assembly (1) and rear
washer pump assembly (2).
CAUTION
Be sure to wear safety equipment to prevent accidents when removing washer pump assembly.
Appropriate force should be applied when removing washer pump assembly. Be careful not to operate
roughly.
Try to prevent body paint surface from being scratched when removing washer pump assembly.
CAUTION
Put a container under washer pump to collect washer fluid before removing washer pump assembly.
1
2
4
3
RT21360260
RT21360270
1
2
36–
38
36
Installation
Installation is in the reverse order of removal.
Inspection
1. Check front/rear washer pump assembly.
a. Fill washer fluid reservoir assembly with washer fluid.
b. Connect positive (+) battery lead to terminal 1 of
washer pump and negative (-) battery lead to terminal
2.
c. Check that washer fluid flows out of washer pump.
OK: Washer fluid flows out of washer pump.
If result is not as specified, replace washer pump assembly.
CAUTION
Always operate carefully to prevent components from being damaged when installing washer pump
assembly.
Install washer line joint in place when installing washer pump assembly.
Check washer system for proper operation after installing washer pump assembly.
RT21360280
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст