Chery Tiggo 5 (T21). Service manual — part 426
37–
44
37
Front Door Key Cylinder
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front left door protector assembly (
4. Remove the front left door assist grip mounting bracket assembly (
).
5. Remove the front left door protective film assembly (
).
6. Remove the front left door key cylinder protective cover.
a. Disconnect the clip (arrow) between front door lock
assembly and front door lock key cylinder lever.
b. Using a screwdriver wrapped with protective tape,
remove the trim plug (arrow) of front door key cylinder
protective cover.
c. Remove the fixing screw from front door key cylinder protective cover, and remove the front left door
key cylinder protective cover.
(Tightening torque: 5 ± 1 N·m)
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing front door key cylinder.
Try to prevent interior and body paint from being scratched when removing front door key cylinder.
RT21370080
RT21370120
37–
45
37
HINT:
It is not necessary to remove the fixing screw from front left door key cylinder protective cover, because
the fixing screw is integrated with the front door key cylinder protective cover.
7. Remove the front left door key cylinder.
a. Detach the clip (arrow) from front door key cylinder
lever.
b. Using a screwdriver wrapped with protective tape,
disengage the claws (arrow) to separate the front door
key cylinder protective cover from front door key
cylinder.
Installation
Installation is in the reverse order of removal.
RT21370130
RT21370140
CAUTION
Install clip on the lever in place when installing front door key cylinder.
Check if front door key cylinder operates properly after installing front door key cylinder.
37–
46
37
Front Door Lock Striker Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the front left door lock striker assembly.
a. Remove 2 fixing crews (arrow) from front left door lock
striker assembly.
(Tightening torque: 10 ± 1 N·m)
b. Remove the front left door lock striker assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing front door lock striker
assembly.
Try to prevent body paint surface from being scratched when removing front door lock striker assembly.
RT21370150
CAUTION
Try to prevent body paint surface from being scratched when installing front door lock striker assembly.
37–
47
37
Rear Door Lock Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear left door protector assembly (
).
4. Remove the rear left door assist grip mounting bracket assembly (
5. Remove the rear left door protective film assembly (
6. Remove the rear left door lock assembly.
a. Disconnect the connector (arrow) from rear door lock
assembly.
b. Detach the cable (arrow) connecting rear door lock
assembly and rear door assist grip base.
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing rear door lock assembly.
Try to prevent interior and body paint from being scratched when removing rear door lock assembly.
RT21370170
RT21370180
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст