Chery Tiggo 5 (T21). Service manual — part 429
37–
56
37
a. Disconnect the connector (arrow) from back door
opener low frequency antenna.
b. Using a screwdriver wrapped with protective tape, pry
up the clip on back door opener low frequency
antenna, and remove the back door opener low
frequency antenna.
10.Remove the front left door protector assembly (
11.Remove the front left door assist grip mounting bracket assembly (
).
12.Remove the front left door protective film assembly (
).
13.Remove the front left door key cylinder protective cover (
).
14.Remove the front left door outside handle (
).
HINT:
Front door handle sensor connector has been
disconnected when removing the front door outside
handle.
15.Remove the front left door handle sensor (built into low frequency antenna) (take left side as an example).
a. Remove the fixing crew (arrow) from front door
outside handle.
(Tightening torque: 1.5 N·m)
RT21370500
RT21470390
RT21370450
37–
57
37
b. Using a screwdriver wrapped with protective tape, pry
up the claws on front door outside handle.
c. Separate the front door handle sensor (1) and front
door outside handle (2).
Installation
Installation is in the reverse order of removal.
RT21370451
RT21370460
1
2
CAUTION
Clip on low frequency antenna and antenna mounting bracket should be fitted properly when installing
low frequency antenna.
Check if functions are normal after installing low frequency antenna.
37–
58
37
Wireless Key
Removal
1. Remove the wireless key (w/ passive entry & passive start).
a. Remove the mechanical key billet in the direction of
arrow as shown in the illustration.
b. Using a screwdriver wrapped with protective tape, pry
out the wireless key cover.
c. Separate the wireless key cover (1) and chip (2).
CAUTION
DO NOT push the terminals with your hands when removing wireless key cover.
Install battery positive and negative correctly when removing wireless key cover.
DO NOT pry up the battery forcibly when removing wireless key cover, otherwise the terminals may be
damaged.
DO NOT touch the battery with wet hands when removing wireless key cover, otherwise the water may
cause rust.
DO NOT touch or move any components inside the transmitter when removing wireless key cover.
Failure to do so may interfere with proper operation.
RT21370310
RT21370320
RT21370330
2
1
37–
59
37
d. Detach the claws (arrow) on battery holder, and
remove the battery holder in the direction of arrow.
e. Take out the battery in the direction of arrow as shown
in the illustration.
2. Remove the wireless key (w/o passive entry & passive start).
a. Using a screwdriver wrapped with protective tape, pry
out the wireless key cover.
b. Take out the wireless key battery in the direction of
arrow as shown in the illustration.
RT21370340
RT21370350
RT21370360
RT21370370
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст