Chery Tiggo 5 (T21). Service manual — part 313
29–
10
29
ON-VEHICLE SERVICE
Steering Fluid Reservoir Assembly
Removal
1. Drain the steering fluid (
2. Remove the steering fluid reservoir assembly.
a. Remove the fluid suction pipe clamp (1) on steering
fluid reservoir, and disconnect the connection
between fluid suction pipe assembly and steering fluid
reservoir assembly.
b. Remove the fluid return pipe clamp (2) on steering
fluid reservoir, and disconnect the connection
between fluid return pipe assembly and steering fluid
reservoir assembly.
c. Pull the steering fluid reservoir assembly upward to remove it from the steering pump bracket.
Inspection
1. Check steering fluid reservoir assembly for breakage or deformation. Replace fluid reservoir if necessary.
2. Check if there is contamination in steering fluid reservoir assembly. Clean or replace if necessary.
WARNING
Be sure to wear necessary safety equipment to prevent accidents when servicing.
When removing and installing high temperature components and surrounding components, wait and
operate until they drops to normal temperature to avoid being burned.
Prevent skin and eyes from contacting with steering fluid.
CAUTION
After disconnecting steering line, seal it immediately to prevent foreign matter from entering.
Never run power steering pump assembly when the steering fluid is insufficient.
Steering wheel should not be in limit positions for more than 5 seconds.
Never start engine with hose loosened or disconnected.
Never allow hose to contact with high temperature exhaust pipe.
1
2
RT21290040
CAUTION
Using a plug, clog the disconnected pipe to prevent foreign matter from entering.
29–
11
29
Installation
Installation is in the reverse order of removal.
CAUTION
Install fluid suction pipe clamp and fluid return pipe clamp in place.
Never tap or hit the fluid reservoir.
29–
12
29
Steering Fluid Pipe
Removal
1. Drain the steering fluid (
2. Remove the front bumper (
3. Remove the fluid suction pipe.
a. Remove the fluid suction pipe clamp (arrow) on
steering fluid reservoir, and disconnect the connection
between fluid suction pipe and steering fluid reservoir
assembly.
b. Remove the fluid suction pipe clamp (arrow) on the
power steering pump assembly side.
c. Loosen the plastic pipe clamp from the front vertical
board of body.
d. Remove the fluid suction pipe.
ENVIRONMENTAL PROTECTION
Collect residual steering fluid in the line with a container when disconnecting the line.
RT21290041
RT21290020
RT21290050
29–
13
29
4. Remove the high pressure fluid pipe.
a. Remove the high pressure fluid pipe joint hollow bolt
(arrow) from the power steering pump assembly.
(Tightening torque: 40 ± 3 N·m)
b. Remove the high pressure fluid pipe clamping bolt
from the steering gear assembly.
(Tightening torque: 30 ± 3 N·m)
c. Remove the high pressure fluid pipe bracket bolt 1
(arrow).
(Tightening torque: 9 ± 1 N·m)
d. Remove the high pressure fluid pipe bracket bolt 2
(arrow).
(Tightening torque: 9 ± 1 N·m)
e. Remove the high pressure fluid pipe.
RT21290021
RT21290060
RT21290061
RT21290070
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст