Dacia Solenza (engine E7J). Manual — part 107
52
52 - 2
MECHANISMS OF NON LATERAL OPENINGS
7
5
6
8
4
11
10
9
9
3
1
2
6
10
11
7
5
4
8
Hatchback lock
TIGHTENING MOMENTS (daNm)
Hatchback latch attachment screw 2.1
Guiding support attachment screw 0.7
Hatchback lock attachment screw 0.6
Changer attachment nut 0.5
DISMOUNTING
Dismount :
- hatchback lock cylinder (1) by remov-
ing the fork (2) and detaching from clips the
changer rod from its arm;
- attachment nut (4) of the hatchback
opening control changer (3) on the hatchback
lining;
- attachment screws (6) of the hatchback
lock on the hatchback lining;
- guiding element (8) and adjustment
washer (7) of the guiding element;
- attachment screws (10) of the guiding
support (9) on the hatchback frame.
- special screw attaching hatchback latch
(11) on the hatchback frame.
REMOUNTING
Perform the dismounting operations in the
reverse order.
52
52 - 3
MECHANISMS OF NON LATERAL OPENINGS
Pneumatic balancing device
DISMOUNTING
Dismount is performed by successive act-
ing upon the safety locks (1) from the pneu-
matic balancing device end (2).
REMOUNTING
Perform the dismounting operations in the
reverse order.
54
54 - 1
GLASSES
Windscreen glass
4
2
3
10 cm
1
DISMOUNTING OF A BROKEN GLASS
If the glass or part of it did not fall, the dis-
mounting and the cleaning of the window gas-
kets by the pieces of the broken glass will be
easier to be made by sticking a sheet of paper
on each surface.
MOUNTING PREPARATION
Position the gasket (2) around the glass (1)
the assembly being placed on a protection plate.
Apply in the gasket channel in the contact area
with carriage body a cord of sealing material
Romtix 1502P 3mm diameter.
Place in the gasket channel all around the
gasket frame; a cotton cord ( 4 ) of 3 – 4 mm
diameter, leaving at its free ends (3) about 20
cm of cord, and between the ends, the distance
shall not be more than 10 cm.
MOUNTING OF THE WINDSCREEN
Mount on the carriage body, the windscreen
– cord - glass gasket assembly, so that the cord
ends are placed towards the inside of carriage
body.
From the inside of the vehicle, successively
draw each end of the cord, the drawing direc-
tion being parallel with the glass surface, to-
wards the surface inner part, perpendicularly
on the frame, beginning with the lower part,
this operation enabling the gasket edge lifting
and then its lowering on the frame.
At the outside, the gasket is seated by
slightly and successively pressing it on glass,
so that the tightening is uniform on the whole
windscreen contour and frame.
The cord must be always removed through
the upper part of the windscreen.
54
54 - 2
GLASSES
Each time a windscreen is mounted, ensure the uniform setting of the whole assembly on the
carriage body by tapping several times with a rubber hammer, on the edge of the glass frame.
REMARK:
Do not tap the glass on corners and on the two vertical sides. Take care that both
spacers are correctly positioned.
After the windscreen mounting check out carefully the uniformity of the whole assembly and
then its waterproofing by splashing with a jet of water.
Windscreen glass
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст