Dacia Solenza (engine E7J). Manual — part 78
FRONT AXLES ELEMENTS
31
31 - 21
Power train support
TIGHTENING MOMENTS (daNm)
Wheels attachment screws
7.5
Shock absorber lower attachment screws
to the steering knuckle arm
10.5
Connecting straps upper attachment screws 2.7
Anti-roll connection rod attachment screws
to the steering crossbar support
6.2
Connection screw of the steering column
lower shaft-steering box gear
2.1
ATTENTION !
Dismounting of the front axles screws
and nuts implies th eir obligatory
replacement and tightening to the required
moments.
DISMOUNTING
Disconnect the battery.
Dismount:
- connection screw of the steering column
lower shaft-steering box gear;
- thermal screen attachment nuts on
exhaust manifold and remove the thermal screen;
- attachment studs descending pipe –
exhaust manifold.
Loosen the front wheels screws.
Lift the vehicle by means of a two-column
elevator.
Dismount the engine shield.
Drain oil from power-assisted steering
circuit ( see chapter 05).
Drain oil from gearbox ( see chapter 05).
Dismount:
- front bumper 9 see chapter 55);
- left/right front wheels fairing ( see
chapter 56);
- connecting straps upper attachments
power train support – carriage body;
- upper attachments of the shock
absorption connecting straps (connecting
straps of suspension arms shafts-carriage
body);
- brake calipers off the fork and
suspend the calipers;
- connection clip of descending pipe-
expansion chamber and remove the
descending pipe.
FRONT AXLES ELEMENTS
31
31 - 22
Power train support
Attach a parts support under the power
train support and dismount:
-
connection screw anti-roll connecting
rod- steering box crossbar support and tilt
over the anti-roll connecting rod downward.
-
clamps attachment of the high pressure
duct of the power-assisted steering ( on the
right side);
-
clamps attachment of the low pressure
duct of the power-assisted steering (on the left
side);
-
attachment screws of the bellows-bearing
GI joint assembly, left transmission on the
gearbox;
-
lower attachment of the cooling radiator,
on both sides;
-
lower attachment screws of the front
shock absorbers, both on left and right side;
-
steering knuckle arms;
-
left transmission from the gearbox;
-
right transmission from the gearbox.
Carefully lower the parts support towards
ground.
Dismount the attachment screws of the power
train support to the longitudinal girders, both at
front part as well at rear part.
FRONT AXLES ELEMENTS
31
31 - 23
Power train support
REMOUNTING
Perform the dismounting operations in the reverse order, observing the tightening moments.
In case a new steering box is to be mounted, perform the parallelism adjustment, observing
the parallelism adjustment procedure previously described.
33
REAR AXLES ELEMENTS
33 - 1
Characteristics
The rear axle is composed of an axle having a “ U “ shaped torsion profile to which arms are
welded
For the transversal stability and the resistance fatigue improvement of the cross- bar, the axle
is equipped with a
Ö 21-mm
diameter stabilizer bar. The bar is inserted by welding on both ends
in the axle side arms.
The connection of the axle with the chassis is realized by elastic bushings of the spiral spring
and the double effect telescopic shock absorber.
The drum and the hub constitute a common body, and are mounted on the steering knuckle
by means of a be-conical sealed bearing.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст