Dacia Solenza (engine E7J). Manual — part 166
87
ELECTRICAL ASSISANCE EQUIPEMENT
87 - 24
Diagnostic – States interpretation
ET193
RECEIVED INFORMATION
RECOMMENDATIONS
Only for “N4” Cockpit Central Unit.
Check that no failure is present
State is declared YES when pushing the remote control
If state is declared NO, set on then set off the contact.
Try again with another key of the vehicle.
ET193
remains at NO : when pushing the remote control
Push the remote control button of some other vehicle of same type or with a new key:
Check that state is becoming YES, when pushing the remote control.
If state is YES, replace the remote control of the breakdown vehicle.
If state is NO, replace the Cockpit Central Unit
Perform again a system diagnostic
Repair the other possible failures
Erase the memorized failures.
AFTER REPARATION
87
ELECTRICAL ASSISANCE EQUIPEMENT
87 - 25
Diagnostic – States interpretation
ET257
PARKING LIGHTS INFORMATION
RECOMMENDATIONS Check that no failure is present or memorized.
Act upon the parking lights control.
State must be ACTIVE, and the parking lights on
Check the bulbs.
Check parking lights fuse F14 (7.5 A)
Replace it if necessary
Check connection and condition of UCH connector EH1 40 pins .
Replace the connector if necessary
Ensure continuity and insulation of the connection:
pin A15 connector EH1 40 pin sfuse box, parking
lights fuse (7.5A)
Fix if necessary.
ET257
INACTIV
Perform again a system diagnostic
Repair the other possible failures
Erase the memorized failures.
AFTER REPARATION
87
ELECTRICAL ASSISANCE EQUIPEMENT
87 - 26
Diagnostic – Damage location algorithm
RECOMMENDATIONS Do not consult these information but after a complete
checking by means of CLIP tester
THERE IS NO COMMUNICATION WITH THE COMPUTER
ALP1
LIGHTING
TURNING LIGHTS ARE NOT WORKING
ALP2
PARKING LIGHTS ARE NOT WORKING
ALP3
WINDSCREEN WIPING
WINDSCREEN WIPER LOW SPEED NOT WORKING
ALP4
WINDSCREEN WIPER HIGH SPEED NOT WORKING
ALP5
87
ELECTRICAL ASSISANCE EQUIPEMENT
87 - 27
Diagnostic – Damage location algorithm
RECOMMENDATIONS
Nothing to notice
Check the tester operation on another vehicle
Check:
- Connection between CLIP tester and the diagnostic socket (cable in good condition).
- Cockpit and engine compartment fuses.
Check presence +12 volts before contact at pin 16, + 12 volts after contact at pin 1
and mass at pins 4 and 5 of the diagnostic socket
Fix if necessary
Check the computer connection.
Connect the multi-socket and check the insulation, continuity and absence of parasite
resistance at connections:
UCH connector P1 pin A1 mass
UCH connector P1 pin A3 fuse box + 12 volts before contact
UCH connector EH1 pin B34 pin 7 diagnostic socket (line K)
Fix if necessary.
.
ALP 1
There is no communication with the computer
Check the system operation
AFTER REPAIRING
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст