Renault Scenic 3 Chassis. Manual — part 31
37A
-
15
MECHANICAL COMPONENT CONTROLS
Brake pedal
LEFT-HAND DRIVE
37A
Unclip the front left-hand side panel.
Remove:
- the dashboard lower section mounting bolts,
- the lower section of the dashboard,
103848
103849
103853
37A
-
16
MECHANICAL COMPONENT CONTROLS
Brake pedal
LEFT-HAND DRIVE
37A
Remove:
- the air duct ,
- the linkage connecting the « brake pedal - bellcrank
rod ».
Disconnect the potentiometer from the accelerator
pedal.
Disconnect the brake light switch.
Turn the brake pedal brake light switch anticlockwise
a quarter of a turn.
104102
104824
19
18
37A
-
17
MECHANICAL COMPONENT CONTROLS
Brake pedal
LEFT-HAND DRIVE
37A
Cut the pin (19).
Insert the pin (Fre. 1752)moving from left to right
(when not replacing the pedal).
Remove:
- the brake pedal yoke mounting nuts (18),
- the « brake pedal - accelerator pedal »assembly,
- the accelerator pedal mounting nuts,
- the accelerator pedal.
REFITTING
104823
19
104824
IMPORTANT
The pedal is fitted with an unlocking system in the
event an impact. Do not strike the pedal system
(20) (this could inadvertently fully depress the
pedal).
Note
- Do not remove the pin before refitting and tigh-
tening the pedal assembly.
20
37A
-
18
MECHANICAL COMPONENT CONTROLS
Brake pedal
LEFT-HAND DRIVE
37A
Cut the pin along the dotted line.
Proceed in the reverse order to removal.
Torque tighten the mounting nuts on the brake pe-
dal fork (21 N.m).
Remove the pin from the pedal.
Adjust the brake pedal position switch (see 37A, Me-
chanical Component Controls, Brake Light
Switch).
Connect the battery, starting with the positive termi-
nal.
104825
104826
IMPORTANT
Check that the connecting piece between the
brake servo pushrod and the brake pedal is loc-
ked in place.
WARNING
Carry out the necessary programming (see 80A,
Battery: Remove and Refit).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст