Dacia SuperNova (engine E7J). Manual — part 100
LOWER INTERNAL ACCESSORIES
57
57 - 10
HANDBRAKE CASE
DISMOUNTING
Dismount the attachment screws (1) of the handbrake case (2) on the central floor.
Remove the handbrake case off the cockpit.
REMOUNTING
Perform in the reverse order the dismounting operations.
1
2
SAFETY ELEMENTS
59
FRONT SAFETY BELTS
DISMOUNTING
Dismount the protectors (1) of the attachments
front safety belts screws on the upper middle
pillar.
Dismount the attachments front safety belts
screws (6) on the lower middle pillar lining.
Dismount the attachment screws (4) of the
lock attachment (5) on the tunnel lining.
REMOUNTING
Perform the dismounting operations in the
reverse order.
59 - 1
3
5
4
6
SAFETY ELEMENTS
59
REAR SAFETY BELTS
DISMOUNTING
Fold the seats (5) and (6) and remove them from supports.
Dismount the protectors (1) of the attachment rear safety belt screws (2) on the rear side panels.
Dismount the attachment screws (3) on the lining lateral frame.
Dismount the attachment screws (4) of the rear belts lock on central floor
REMOUNTING
Perform the dismounting operations in the reverse order.
The safety belts attachment screws are to be tighten at a moment of 2.7 daNm.
1
2
4
3
5
6
59 - 2
HEATING
61
61 - 1
DISMOUNTING
Disconnect the battery.
Dismount the documents compartment.
Dismount the attachment clip of the mixing flow flap control cable, (8) (from the climate
control unit).
Remove the right aeration grill (from the right side of the central console).
Dismount the attachment clip of the distribution flow flap control cable, (7)(from the climate
control unit).
Dismount the attachment metal screws (5) of the climate control assembly (6) on the central
console of the dashboard.
Remove the climate control assembly from its seat.
Disconnect the connection box of the climate control switch.
Disconnect the connection box of the instrument panel lighting.
Dismount the attachment clip of the recycling flow flap control cable (9) and remove it from its seat.
Remove: the mixing flow flap control cable (8) from the heating control button (2) and the
distribution flow flap control cable (7) from the distribution control button (3), by releasing the
clips attachment screws.
Remove the climate control switch (4) out of its seat by detaching from clips.
Dismount the four lighting bulbs.
REMOUNTING
Perform in the reverse order the dismounting operations, taking into account the following
recommendations:
- the flow flaps control cables are first fixed to the board with the jacket, in axial contact
with the limiting support and then pass the panel button and the similar flow flap on the
corresponding position, then clamp the cable to the unit support;
- check if the levers from the climate unit and from the distribution box, have the adequate
strokes to ensure the close-opening of the flow flaps;
- if yes, mount the assembly (6) on the central console, the documents compartment and
the aeration grill ;
- if not, set the sleeve length of each control cable to the mounting bracket of the climate
unit and the distribution box.
- the maximum moment for the full flow flaps opening is 1,9 Nm.
CLIMATE CONTROL ASSEMBLY
9
8
7
6
1
2
3
4
5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст