Dacia Pick-Up 1304/1305/1307. Manual — part 110
SIDE OPENING ELEMENTS MECHANISMS
51
51 - 2
FRONT/REAR DOOR OPENING MECHANISM
D
ISMO UNTING
Before dismounting the door lock control , remove the door panel and leave the window
in the lift position.
Dismount:
- opening knob (1);
- ornament (3) attachment screws (2);
- the attachment screw (4) of opening mechanism (5);
- control lever (6)off the hinge, releasing the opening mechanism.
R
EMO UNTING
Perform the dismounting operations in reverse order.
1
3
4
2
5
6
51
SIDE OPENING ELEMENTS MECHANISMS
51 - 3
D
ISMO UNTING
To dismount the door window regulator assembly, perform the following operations:
Bring the window in the position P = 85 mm.
Unscrew the attachment nuts (10), press the shaft (11) for releasing the window regulator
towards the inner side.
R
EMO UNTING
For remounting perform the following operations:
Place in it housing the outside wiper (15) assembled with bracket (15’).
Easy bend the “ window regulator-
window “ assembly, take out the supports
(12), the slides from the window base (13)
and the glass slide (14).
In order to re mount the glass slide, easy
curve it in (F) and (G) ensuring a correct
attachment in the door frame.
Lift the window regulator in the
position J = 40mm,introducing the glass
through the door frame, with the top down
(16) center it in its slide and bring it in
position P = 85mm.
FRONT DOOR WINDOW REGULATOR
SIDE OPENING ELEMENTS MECHANISMS
51
51 - 4
Put in its place the window regulator , introducing the shaft (11) in the frame than the
attachment washer (17) and attachment nuts (10).
Place the supports (12) at the glass bottom and perform a first sliding test.
Grease the window regulator hinges and supports and perform the others operations in
reverse order.
PREPARING THE GLASS BASE
When fitting the bottom edge and at the
glass positioning in the slide-bars, observe the
value of 92 mm.
FRONT DOOR WINDOW REGULATOR
51
SIDE OPENING ELEMENTS MECHANISMS
51 - 5
In order to dismount a door window and the
window regulator of the back door
window, perform the following operations:
Remove the screws (11) and (12).
Using the technological opening (14) in the
inner side of the door , remove the elastic
washer and the safety washer (20), which
make the connection with the window slide-bar,
by slightly sliding it to the lower part.
Remove the three screws (15),releasing the
back window regulator (19) and remove it
from the inner door.
D
ISMO UNTING
REAR DOOR WINDOW REGULATOR
R
EMOUNTING
For remounting , the operations shall be performed in the reverse order :
Replace the channel support in the rear inner side of the door , place the assembly
inside the door frame, then remove again the frame , to allow the placing of the window in
the channel support.
Replace the window regulator mechanism (19) and temporally attach its sealing washer
(R).
The window placed in the channel support shall be secured by means of the safety
gasket and the washer (20) and the lateral frame from the window attachment (21) shall be
temporally attached by means of the screws (11) and (12), using the technological opening
(22) ; test rolling up the window several times , after which completely tighten the screws.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст